Advertisement
Quick Links
ACC514, ACC516 - Quick Start Guide
·
Handle the equipment carefully, holding force can be reduced by damaging the bolt body or
detector plate.
·
The electric bolt lock should be fixed tightly on the door frame and the detector plate on the door
leaf.
·
Shut off all power to the access control system before wiring this device.
·
Maintain a clean and safe environment at all times.
Definition
NO (Normally Open) - This is a contact which remains open (as default) until activated, during the
"active" state the contact provides a closed circuit and starts conducting.
NC (Normally Closed) - Is the opposite of a NO contact. The contact will remain closed (as default)
until activated, during the "active" state the circuit breaks and stops current flow.
Connections
ACC514
Red
= +12V DC
Yellow
Black = GND
White
Purple
Setup Example
Electric bolts are an efficient method of adding secure access
control to a door.
An electric bolt will protrude out as long as there is power being
supplied and then detector plate is present.
For a "Fail Safe" setup, when the button is activated, power
supply then releases power from the lock, and if power is lost
then the lock also releases.
You would connect the control device and power to the bolt via an
access control panel, relay or exit button so that the power can be
cut when triggered. When powered up again the bolt protrude
again locking the door in place.
Document ref: qACC514-516
Electric Bolts
The ACC514 has an adjustable delay and status relay output
which can be connected to a buzzer or light to produce a
visible or audible alert when the door is opened.
The ACC516 has an adjustable delay of up to 6 seconds, a
relay output to alert when the door is opened and LED
indicator to show the bolt status.
User Information
·
There are no user serviceable parts, opening or attempting
to repair the product will void the warranty.
·
Do not install or use the device if the wires connected are
damaged or have been subjected to water ingress
= NO
= COM
= NC
ZapCCTV.com
Zap is a registered trademark of System Q Ltd
ACC516
Red
= +12V DC
Yellow
Black = GND
White
Electric Bolts
= NC
= COM
© 2022 System Q Ltd
1
Advertisement
Related Manuals for Zap ACC514
Summary of Contents for Zap ACC514
- Page 1 Zap is a registered trademark of System Q Ltd ACC514, ACC516 - Quick Start Guide Electric Bolts The ACC514 has an adjustable delay and status relay output which can be connected to a buzzer or light to produce a visible or audible alert when the door is opened.
- Page 2 Electric Bolts Zap is a registered trademark of System Q Ltd Mounting ACC514 1. Cut a rebate in the door for the detector plate, and cut the hole for the electric bolt using the template provided. 2. Ensure a channel or hole is made for the cables and ensure they are protected by using a protection guard or conduit if exposed.