Remote Control And Wireless Keypad; To Erase The Memory - Craftsman CMXEOCG322 Owner's Manual

REMOTE CONTROL AND WIRELESS
KEYPAD
Pre-programmed remote control included, no need to program the
remote.
To add or reprogram a remote control, follow the instructions below.
PROGRAM USING THE DOOR CONTROL
1. Press the LEARN button on the door control to enter
Programming Mode.
2. Press the LEARN button again, the LED will flash once.
3. Remote Control: Press the button on the remote control that
you wish to operate your garage door.
Wireless Keypad: Enter a 4-digit personal identification
number (PIN) of your choice on the wireless keypad. Then
press the ENTER button.
The garage door opener lights will flash (or two clicks will be heard)
when the code has been programmed.
1
The command LED
will flash once.
3
2
The command LED will
flash once again.
OR
? ? ? ?
PIN

TO ERASE THE MEMORY

ERASE ALL REMOTE CONTROLS AND WIRELESS
KEYPADS
1. Press and hold the LEARN button on garage door opener until
the learn LED goes out (approximately 6 seconds). All remote
control and wireless keypad codes are now erased.
Reprogram any accessory you wish to use.
ERASE ALL DEVICES (INCLUDING myQ
ENABLED ACCESSORIES)
1. Press and hold the LEARN button on garage door opener until
the learn LED goes out (approximately 6 seconds).
2. Immediately press and hold the LEARN button again until the
learn LED goes out. All codes are now erased. Reprogram
any accessory you wish to use.
ERASE THE CONNECTION FROM GARAGE DOOR
OPENER TO HOME Wi-Fi NETWORK
1. Press and hold the black adjustment button on the garage
door opener until 3 beeps are heard (Approximately 6
seconds).
37
®