Install The Sprocket Cover; Installation; Important Installation Instructions - Craftsman CMXEOCG322 Owner's Manual

ASSEMBLY STEP 6

INSTALL THE SPROCKET COVER

To avoid possible SERIOUS INJURY to finger from moving garage door opener:
• ALWAYS keep hand clear of sprocket while operating opener.
• Securely attach sprocket cover BEFORE operating.
1. Position the sprocket cover over the sprocket as shown and
fasten to the mounting plate with #8x3/8" hex screws
provided.
HARDWARE SHOWN ACTUAL SIZE

INSTALLATION

IMPORTANT INSTALLATION INSTRUCTIONS

To reduce the risk of SEVERE INJURY or DEATH:
1. READ AND FOLLOW ALL INSTALLATION WARNINGS AND
INSTRUCTIONS.
2. Install garage door opener ONLY on properly balanced and
lubricated garage door. An improperly balanced door may NOT
reverse when required and could result in SEVERE INJURY or
DEATH.
3. ALL repairs to cables, spring assemblies and other hardware
MUST be made by a trained door systems technician BEFORE
installing opener.
4. Disable ALL locks and remove ALL ropes connected to garage
door BEFORE installing opener to avoid entanglement.
5. Where possible, install the door opener 7 feet (2.13 m) or more
above the floor.
6. Mount the emergency release within reach, but at least 6 feet
(1.83 m) above the floor and avoiding contact with vehicles to
avoid accidental release.
7. NEVER connect garage door opener to power source until
instructed to do so.
8. NEVER wear watches, rings or loose clothing while installing or
servicing opener. They could be caught in garage door or
opener mechanisms.
Hex Screw #8x3/8"
(Packed with the
sprocket cover)
Hex Screws
Sprocket Cover
You have now finished assembling your garage door opener.
Please read the following warnings before proceeding to the
installation section.
9. Install wall-mounted garage door control:
• within sight of the garage door.
• out of reach of small children at a minimum height of
5 feet (1.5 m) above floors, landings, steps or any other
adjacent walking surface.
• away from ALL moving parts of the door.
10. Place entrapment warning label on wall next to garage door
control in a prominent location.
11. Place emergency release/safety reverse test label in plain view
on inside of garage door.
12. Upon completion of installation, test safety reversal system.
Door MUST reverse on contact with a 1-1/2" (3.8 cm) high object
(or a 2x4 laid flat) on the floor.
13. DO NOT install on a one-piece door if using devices or features
providing unattended close. Unattended devices and features
are to be used ONLY with sectional doors.
12
Hex Screws
OR
Sprocket Cover