Advertisement
Table of Contents
Temperatur Control Technology
www.hb-therm.ch
2020-01
Page
Assembly Instructions M8107-EN
Spare part cooling valve 2 (O/ID T25932-X, T25933-X)
M8107-EN 2020-01
Purpose
Replacement of hydraulic parts cooling valve 2 (M 4)
Precondition
WARNING!
Danger for unauthorized persons!
Conversion work may only be carried out by
specialist staff who have been trained accordingly.
Therefore:
– Keep unauthorized persons away from the work
area.
NOTE!
Knowledge of the Instruction Manual is a
precondition for carrying out conversion work on
the unit.
Procedure
DANGER!
Danger to life caused by electric current!
Touching conductive parts causes a direct danger
to life.
Therefore:
– For all work on the electrical system, for
maintenance, cleaning or repair work,
disconnect from the mains or disconnect all
phases of the external power supply and secure
them against being switched on again. Check
unit is isolated from power supply.
WARNING!
Danger of crushing due to rolling away or
tipping
With an uneven floor or when the castors are not
locked, there is a danger that the unit tips over or
rolls away causing crushing.
Therefore:
– Only install the unit on an even floor.
– Ensure that the castors are locked.
1/4
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for HB-THERM T25932-1
Summary of Contents for HB-THERM T25932-1
- Page 1 Temperatur Control Technology www.hb-therm.ch 2020-01 Page Assembly Instructions M8107-EN Spare part cooling valve 2 (O/ID T25932-X, T25933-X) Purpose Replacement of hydraulic parts cooling valve 2 (M 4) Precondition WARNING! Danger for unauthorized persons! Conversion work may only be carried out by specialist staff who have been trained accordingly.
- Page 2 Assembly Instructions M8107-EN Proceed as follows in order to cool down the unit and empty the mould (mould evacuation): Display menu page Functions. Select the function Cooling and activate with the key. If the function Mould evacuation is available, select it and activate it with the key.
- Page 3 Assembly Instructions M8107-EN Proceed as follows to insert the guide sleeve and piston: NOTICE! Do not remove the mounting rod to assemble the guide bush. Assemble new guide sleeve and fix it with Torx lock screw. With T25933-X Clean piston and rod. ...
- Page 4 Assembly Instructions M8107-EN Press the key to switch on the unit, check unit functions and check it for leaks. Switch the unit off by press the key. 10. Main switch off. 11. Close the unit correctly again. Parts list O/ID Description O/ID Piston complete...
Need help?
Do you have a question about the T25932-1 and is the answer not in the manual?
Questions and answers