Advertisement
Available languages
Available languages
WARNINGS
- Do not use the appliance in the vicinity of showers, bath tubs, wash basins,
swimming pools, etc.
- Always use the heater in an upright position.
- Do not use the heater to dry your laundry. Never obstruct the intake and outlet
grilles (danger of overheating).
- The heater must be positioned at least 50cm from furniture or other objects.
- Do not place the appliance up against walls, furniture, curtains, etc.
- The appliance must be installed so that the switches and other controls
can not be reached by persons using the bath tub or the shower.
- This appliance comes with a Y-type connection. Replacement of the feed cable
must be entrusted to a technician only, because such work requires special tools.
- The appliance must not be positioned directly underneath a fixed power point.
- Do not use the appliance while it is cooling down, in order to avoid overheating with
the attendant risk of fire.
- Do not use the appliance in rooms less than 4m2 area.
The heater is fitted with a safety device which will switch off the heater in case of
accidental overheating (eg. Obstruction of air intake and outlet grilles, motor turning
slowly or not at all).
To reset, disconnect the plug from the power for a few minutes, remove the cause of
overheating then plug the appliance in again
OPERATION OF YOUR HEATER
·Remove the heater from all packaging and place it in desired location.
·Ensure that there is a safe area between the heater and furniture,curtains,etc-50cm
safe area form top and sides and 120cm safe area in front.
·Unwind the Power Cord and plug it into the Power Outlet.
·To activate the heater ,turn the knob clock-wise to the '
'position for cool
air.Turn knob to 'I' for low power, ' II' for maximum power.
AUTO SATETY SHUT OFF
The heater has a built-in safety device,which will switch the heater OFF in case of
accidental overheateing.To reset the heater,follow the next steps:
·Turn the control setting to the 'O' position.
·Unplug the heater and wait 5-10 minutes for the unit to cool down.
·After the unit has cooled, plug it in and operate normally.
·Turn salector switch into desired position(Fan,Low or High).
·Turn the thermostat switch to the desired temperature positon.
·When you feel the room temperature comfortable, turn the thermostat switch
anti-clockwise slowly to the minimal direction until the appliance switches off.
·The thermostat switch will keep the room temperature at the desired temperaturea
utomatically.
·You can also turn the thermostat switch anti-clockwise to the minimum position or
turn the thermostat switch clockwise to the maximum position to make the
temperature lower or higher.
8
Advertisement
