Left I/O board cable
Remove the pogo pin bracket
Make sure the following FRUs (or CRUs) have been removed.
"Remove the LCD module" on page 26
Step 1.
Remove four screws, and then remove the pogo pin bracket.
Figure 13. Remove four screws and remove pogo pin bracket
Screw specifications
M1.4 x L2.5
Go to
https://support.lenovo.com/partslookup
replacement part:
Pogo pin bracket
Remove the heat sink
Make sure the following FRUs (or CRUs) have been removed.
"Remove the LCD module" on page 26
Step 1.
Remove six screws, and then remove the heat sink.
Number of screws
4
to look up the Lenovo part numbers of the following
.
Chapter 4
Removing a FRU or CRU
33