Advertisement
INSTALLATION
Wall mount
Camera base
Rev Date: 08/21
2. Installation
1
Using the mounting template or the mounting bracket itself, mark and drill the
necessary holes on the mounting surface.
2
Secure the mounting bracket to the mounting surface using the screws and
anchors included. Use the mounting pad between the bracket's arm and
mounting surface as needed.
3
Affix the safety wire at the bottom of the mounting bracket's case. Connect the
other side of the safety wire to the base of the camera.
4
Pass wires through and make all necessary connections.
5
Secure the camera to the mounting bracket using
the included screws. Align the indented lines on the
side of the camera with the lines on the mounting
bracket as seen in the image on the right.
Rotate the camera clockwise to lock into position.
6
Adjust the camera modules' position and angle and complete the installation
by placing the dome cover on the camera. Secure the dome cover to the camera
base using the screws included with the camera. See the camera's QSG for
more information.
NOTE:
Do not touch the lenses when handling the camera modules.
Camera dome cover
Quick Start Guide
Fix it with Safety Wire on the
1
case and fasten it to fit the jo
Bracket and Bottom case we
UNLOCK
Remove the Rubber cap and
2
with a screw.
Secure the dome cover to th
3
bottom case using the torx
Remove the protective film
4
camera's dome to complete
installation.
Copyright © Digital Watchdog. All rights reserved.
Specifications and pricing are subject to change without notice.
LOCK
Advertisement
