Advertisement
Connecting to the DTE Equipment
8776-A2-GZ40-10
Connection to the four ports of the 8776 Termination Unit is through the 50-pin
interface connector on its faceplate. Refer to Appendix C, Connector Pin
Assignments , in the User's Guide.
Procedure
To connect the Hotwire 8776 Termination Unit to your DTE equipment:
1. Connect the 50-position connector of the cable to the connector on the
faceplate of the 8776 Termination Unit. Align one end of the cable connector
with the card connector, then push on the cable connector until it seats.
The end of the cable connector has a release button. To remove the
connector, press the release button and pull the connector away from the
card.
- 4 8
A
4 8
2. Feed the cable through the Cable Guide if it is in use. When all cables are
installed, anchor them with cable ties to the rack, DSLAM, or Cable Guide.
3. Connect the four terminating connectors to your DTE equipment.
August 1998
N F
R T
G
V
B
A
B
V D
G.703
Interface
98-15726-01
7
Advertisement
