Advertisement
Cables You Need
Installing DSL Cards
8776-A2-GZ40-10
The following standard cable is used with this product.
For the network connection:
Plug-ended Telco 50-pin cable for connection from the Hotwire 8600 DSLAM
LINE port or one of the Hotwire 8800 DSLAM LINES ports to the Main
Distribution Frame (MDF) or other demarcation point.
For the DTE connection:
For further information refer to Appendix C, Connector Pin Assignments , in
the User's Guide.
Use a small- to medium-size flat-blade screwdriver to install the 8776 Termination
Unit.
When installing the unit
into a . . .
Hotwire 8600 DSLAM base
chassis
Hotwire 8600 DSLAM
expansion chassis
Hotwire 8800 DSLAM
chassis
A Hotwire 8776 Termination Unit can be installed, removed, and replaced from a
the DSLAM chassis without disrupting service to the other cards in the chassis.
NOTE:
When installing the Termination Unit, you need to remove the filler plate
before proceeding.
Do not discard unused filler plates. Each slot in the chassis must contain a
circuit card or a filler plate. Store all unused filler plates in a safe place. You
may need to use the filler plates to cover open slots in the chassis at a later
time.
August 1998
Place the termination unit in . . .
Slot 2 or 3 (Slot 1 of the Hotwire 8600 DSLAM base
chassis must contain a Management Communications
Controller (MCC) card).
Slot 1, 2, or 3.
Any one of the first 18 slots (i.e., Slot 1 through 18).
3
Advertisement
