...................................................................... 2
.............................................................. 6
................................................................. 11
.................................................................... 12
TOOLS NEEDED .......................................................... 12
WORK CLAMP ............................................................. 13
DUST BAG .................................................................. 13
............................................................ 15
NOTE:
The manual cover illustrates the current production model. All other illustrations contained in the manual are representative
only and may not be exact depictions of the actual labeling or accessories included. They are intended for illustrative purposes only.
PRODUCT SPECIFICATIONS
Cutting Capacity
(Maximum nominal
lumber sizes)
Baseboard (Vertical)
Crown (Vertically Nested) 7.5 inch
Net Weight
Input
Blade Arbor Hole
Blade Diameter
No Load Speed
Blade Max Speed Rating
Number of Teeth
Blade Thickness
Blade Kerf
TABLE OF CONTENTS
...................... 6
......... 7
............ 8
..................................... 9
............................................. 10
FEATURES
0° Miter/0° Bevel: 4 inch x 10 inch
(2 x 12 inch Extended Capacity)
45° Miter/ 0° Bevel: 4 inch x 6 inch
0° Miter/45° Bevel: 2 inch x 10 inch
(Left & Right 45° Bevel:1 inch x 10
inch)
45° Miter/45° Bevel: 2 inch x 6 inch
(Left & Right 45°Bevel: 1 inch x 6
inch)
6 inch
57 lbs
120 V~, 60hz, 15 Amps
1 inch
12 inch
4,000 r/min (RPM)
5,500 r/min (RPM)
40
0.079 inch (2mm)
0.11 inch (2.8mm)
THROAT PLATE ........................................................... 19
................................................................. 22
FOR MITER CUTS ........................................................ 25
FOR BEVEL CUTS ........................................................ 26
SLIDE CUTS ................................................................ 28
............................................................ 32
LUBRICATION ............................................................. 32
................................................. 33
............................................................. 33
BLADE DESCRIPTIONS
APPLICATION
Construction Saw Blades
(thin kerf with anti-stick rim)
General Purpose
Fine Crosscuts
Woodworking Saw Blades
(provide smooth, clean cuts)
Fine crosscuts
NOTE:
ONLY use blades that are marked for speeds of
4,000 r/min (RPM) or higher. NEVER use a smaller diameter
blade. It will not be guarded properly. Use crosscut blades
only. DO NOT use blades designed for ripping, combination
blades or blades with hook angles in excess of 7°.
2
..................... 20
. 34
DIAMETER
TEETH
12 inch (305mm) 40
12 inch (305mm) 60
12 inch (305mm) 80