DeWalt DCV585 Manual page 12

English
Automatic Filter Cleaning System
This dust extractor has a highly effective filter cleaning
system which minimizes filter clogging. Every 20 seconds,
both filters gets automatically cleaned. The cleaning process
alternates between the filters and continues through the life
of the unit.
nOTE: It is normal to hear a clicking sound during
this process.
nOTE: After extended operation, the automatic filter
cleaning system may not be effective. When this happens,
the tank should be emptied and the filters may need to be
cleaned or replaced.
To Remove Filters (Fig. A, H)
1. Press the two position switch
and remove the battery.
2. Release tank latches 4
head 6 from canister. Place dust extractor head on a
level surface on its side.
3. Turn each HEPA filter
carefully remove from dust extractor head, ensuring
debris does not fall into mounting hole.
nOTE: Use care to not damage filter material.
Fig. H
18
4. Inspect filters for wear, tears or other damage.
nOTE: If there is any doubt on the condition of the
filters, they MUST be replaced. DO NOT continue use if
filters are damaged.

WARNING: Never use compressed air or a brush to
clean filters, otherwise damage to the filter membrane
will occur which will allow dust to pass through the
filter. If needed, rinse with room temperature water
and let air dry. Cleaning of the filters is typically
unnecessary. Even if the filter is covered with dust,
the automatic filter cleaning system will maintain
maximum performance and continue to function. If
visual damage to the filter membrane exists, replace
filters. Filters typically last between six and twelve
months, depending on use and care.
10
3 to the Off (O) position
and remove dust extractor
18 counterclockwise, and
20
27
To Install Filters (Fig. A, H)

WARNING: The filters must always be in place
while vacuuming.
1. Ensure filter seal is in place and is not damaged
20
or dirty.
2. Line up the tabs on the HEPA filter
on the dust extractor head and using moderate force,
push down and turn clockwise until the filter is secure.
nOTE: Use care to not damage filter material.
3. Place the dust extractor head
secure it by closing the tank latches
Installing the Paper or Fleece Bag
(Fig. A, G, I)
When vacuuming fine dust, you may also use an additional
paper bag or fleece bag
tank 16 easier.
1. Press the two position switch
and remove the battery.
2. Unlatch the tank latches
extractor head 6 from the tank
3. Attach the bag by passing the two tabs
opening past the two notches
4. Rotate the bag a quarter turn until the square edge
is facing upward.
Fig. I
23
22
5. Fit bag inside the tank ensuring it is not folded
or pinched.
6. Replace dust extractor head onto the tank and
latch securely.
Removing and Disposing the Bag
(Fig. A, G, J)
1. Press the two position switch
and remove the battery.
2. Unlatch the tank latches
extractor head 6 from the tank
nOTE: It is normal for there to be a small amount of
dust in the tank even with the the bag properly installed.
3. Rotate the bag until the two tabs align with the two
notches on the dust extractor and remove the bag.
4. Once the bag is removed it can be sealed for disposal.
18 to the notches
6 onto the tank
4 .
12 to make emptying the
3 to the Off (O) position
4 and remove the dust
16 .
21 on the bag
22 on the dust extractor.
3 to the Off (O) position
4 and remove the dust
16 .
16 and
23
21