Additional Instructions; Maintenance; Troubleshooting; The Vacuum Does Not Function Properly - Primula Eco DOB Manual

 Turn on the main switch No 01.
 Switch the thermostat No 02 on MAX position during the winter and on MIN position during the
summer. The red led lamp (No 03), will indicate when the heating is on. When you want to
inactivate the heating switch the thermostat knob (No 02) to the zero (0) position.
 Whenever you want to use the suction just press the suction pedal.
 Adjust the steam quantity of the steam generator in proportion to the suction performance of
the table, in order to avoid steam liquidation on the working surface. The refined fabrics require
small quantity of steam, while the gross fabrics require big quantity of steam.
 The ironing buck's heating is activated when you press switch No 05 to position I.

6.3 Additional Instructions

In case the table disposes a Vario iron system (optional):
 Hook the steam iron from the balancer and adjust the distance of the steam iron from the
working surface (approximately 5cm). After you have finished ironing, unhook the steam iron
from the balancer and put it on the iron rest mat.
In case your table disposes a blowing system of air:
 Push with your foot pedal for using the blowing.

7. Maintenance

 Make sure that the covers of the table and the ironing buck remain clean, in order to have high
performance of suction and blowing air. Wash periodically the blue polyester fabric and the
foam blue in the washing machine (30-40
foam, do not wash it in the washing machine, but wash it by hand. Replace them regularly, in
order to keep high suction and blowing performance.
 Clean the dust of the fan wheel /impeller at least 2-3 times per year.
 Clean periodically and grease the arm's as well as the buck's bearings.
 Clean periodically the internal parts of the table as well as the electronic circuit by using
compressed air.
 Keep the machine clean.
CAUTION!
Before doing maintenance work, please disconnect the machine from the electrical power supply.

Troubleshooting

8.
For the instructions mentioned in the current section please see the drawing of the spare parts of the
machine on page 10.

8.1 The vacuum does not function properly

 Check if there is power supply.
 Check if the power feeding cable No 05 is for some reason cut off.
 Check the fuse 12Α inside the fuse case No 07.
 Check if the suction's button pedal No 21 is faulty.
 Check if the motor No 01 is for some reason damaged.
8.2 The heating of the ironing buck is not activated
 Check the buck's cable and plug.
ο
C).In case you use felt molletone instead of blue
.
8
Instruction Manual