How To Change The Working Surface From Dob To Fl Surface And Vice Versa; Additional Instructions - Primula Tailor Manual

 Whenever you want to use the suction just press the foot pedal.
 Adjust the steam quantity of the steam generator in proportion to the suction performance of
the table, in order to avoid steam liquidation on the working surface. The refined fabrics require
small quantity of steam, while the gross fabrics require big quantity of steam.
 The ironing buck's heating is activated when you press switch No 02 to position I.

6. How to change the working surface from DOB to FL surface and vice versa.

For the instructions mentioned in the current section please see the below images (picture 3).
4
Image 1: Disconnect the plug No 04
Image 3: Place the surface into the holes No 06
Picture 3: Images for explaining the change of the working surface from DOB to FL surface and vice
versa:
 Disconnect the plug No 04 (image 1).
 Unscrew the knob No 05 to the left (image 2).
 Pick up slightly, pull out and remove the placed surface.
 Place the new surface into the suitable holes No 06 (Image 3).
 Screw the knob No 05 to the right (image 2).
 Connect the plug No 04 (image 4).

7. Additional Instructions

In case the table disposes a Vario iron system (optional):
 Hook the steam iron from the balancer and adjust the distance of the steam iron from the
working surface (approximately 5cm). After you have finished ironing, unhook the steam iron
from the balancer and put it on the iron rest mat.
In case your table disposes a blowing system of air:
 Push with the foot pedal.
 Pull up the lever No 03 (see the picture 2 on page 6).
 Keep your foot on the pedal. Since you do not push the foot pedal, the function reverts to the
suction.
6
5
Image 2: Knob No 05
Image 4: Connect the plug No 04
7
Instruction Manual
4