Viessmann Solar-Divicon PS10 Installation And Service Instructions Manual page 12

Installation sequence
Installing the Solar-Divicon
3.
1.
Fig. 7
1. After you have removed the upper insulation shell,
remove the cardboard transport protection.
3. Remove the flow and return lines to make installa-
tion easier.
If you are installing a Solar-Divicon, type PS20,
remove the spring clip before removal.
12
(cont.)
9.
10.
2.
5.
6.
7.
9.
9. Versions:
Installation with copper pipes
■
Insert the support sleeves into the solar circuit
pipes and secure with valve connections.
■ Installation with stainless steel solar circuit
pipe
Trim and deburr in the valley of the corrugation;
do not damage the peak of the corrugation.
Fit the union nut, half washer (in the 5th valley)
and O-rings (in the 1st and 3rd valley).
4.
Ø10
8.