Wipers And Washers - Honda Civic 2022 Manual

Hide thumbs Also See for Civic 2022:
Table of Contents

Advertisement

Wipers and Washers

Windscreen Wipers/Washers
MIST
a
OFF
b
INT
*1
/AUTO
*2
c
LO: Low speed wipe
d
HI: High speed wipe
e
Washer
f
Intermittent Time Adjustment
g
Ring
*
*1 : Models with manual intermittent operation
*2 : Models with automatic intermittent operation
* Not available on all models
uuOperating the Switches Around the Steering WheeluWipers and Washers
The windscreen wipers and washers can be
used when the power mode is in ON.
MIST
The wipers run at high speed until you release
the lever.
Wiper switch (OFF, INT
*1
/AUTO
Move the lever up or down to change the
wiper settings.
Adjusting wiper operation
Turn the adjustment ring to adjust the wiper
operation.
Lower speed, fewer sweeps
Higher speed, more sweeps
Washer
Sprays while you pull the lever toward you.
When you release the lever for more than one
second, the spray stops, the wipers sweep two
or three more times to clear the windscreen,
then stop.
1Wipers and Washers
NOTICE
Do not use the wipers when the windscreen is dry.
The windscreen will get scratched, or the rubber
blades will get damaged.
NOTICE
Turn the washers off if no washer fluid comes out.
The pump may get damaged.
*2
, LO, HI)
The wiper motor may stop motor operation
temporarily to prevent an overload. Wiper operation
will return to normal within a few minutes, once the
circuit has returned to normal.
*
Models with intermittent time adjustment ring
If the vehicle speeds up while the wipers are
operating intermittently, the length of the wipe
interval shortens.
When the vehicle speeds up, the wiper operation's
shortest delay setting (
become the same.
NOTICE
In cold weather, the blades may freeze to the
windscreen.
Operating the wipers in this condition may damage
the wipers. Use the demister to warm the
windscreen, then turn the wipers on.
If the wipers stop operating due to an obstacle such
as the buildup of snow, park the vehicle in a safe
place. Rotate the wiper switch to OFF, and set the
power mode to ACCESSORY or VEHICLE OFF, then
remove the obstacle.
Continued
) and the LO setting
205

Advertisement

Table of Contents
loading

Table of Contents