uuIf the Battery Is DeaduJump Starting Procedure
■
What to Do After the Engine Starts
Once your vehicle's engine has started, remove the jumper cables in the following
order.
1. Disconnect the jumper cable from your vehicle's stud bolt.
2. Disconnect the other end of the jumper cable from the booster battery -
terminal.
3. Disconnect the jumper cable from your vehicle's battery + terminal.
4. Disconnect the other end of the jumper cable from the booster battery +
terminal.
Have your vehicle inspected by a nearby service station or a dealer.
* Not available on all models
616
1If the Battery Is Dead
The Vehicle Stability Assist (VSA) system, Vehicle
Stability Assist (VSA) OFF, Adaptive Cruise Control
(ACC) with Low Speed Follow, low tyre pressure/
deflation warning system
*
and safety support
indicators may come on in amber along with a
message in the gauge when you set the power mode
to ON after reconnecting the battery.
Drive a short distance at more than 20 km/h. Each
indicator should go off. If any do not, have your
vehicle checked by a dealer.