Table of Contents
Advertisement
Cellular Needs Alignment— Service to your unit is required. Contact
GARMIN Product Support.
Data Transfer Complete— The unit has finished uploading or download-
ing information to the connected device.
Degraded Accuracy— The NavTalk Pilot' s GPS accuracy has degraded
beyond 500 meters due to poor satellite geometry or data quality. Check other
navigational sources to verify the position indicated.
ESN Not Available— Your cellular electronic serial number is missing.
Contact your authorized GARMIN dealer.
Ignition Power Off— Power to the Vehicular Adapter has been turned off
when the ignition switch was turned off. The unit will switch to a charging
mode and/or turn off automatically when timed out as set in the 'System" Page.
Inside Airspace— Your aircraft has entered the boundaries of special-use or
controlled airspace.
Leg not Smoothed— The upcoming route leg is too short for smooth
waypoint transitions.
Location Transfer Complete— Your GPS location DTMF signal has been
received and recorded.
Location Transfer Failed— Your GPS location DTMF signal tone was not
received. NavTalk Pilot sends 5 times before this message appears.
Maintenance Mode— The cellular system is conducting maintenance or
running a test on your phone.
Memory Battery Power Low— The battery that sustains the user memory
is low and should be replaced by an authorized service center as soon as
possible. Failure to do so may result in loss of stored data, including all user
waypoints and routes.
Name Already Exits— You have already entered the same name in the
database.
Near Airspace, Less Than 2 nm— Your position is within 2 nautical miles
of an airspace and your current course will not take you inside.
Need Altitude for 2D Nav— The NavTalk Pilot needs altitude input in
order to start or continue 2D navigation.
Appendix D
Messages
143
Advertisement
Table of Contents
