A) Adding A Scan Profile; B) Copying A Scan Profile; C) Editing A Scan Profile; D) Deleting A Scan Profile - abi SENTRY Operator's Manual

a) Adding a scan profile

To add a profile, click the
carry out the following steps :
Profile Name
 Enter a suitable
 Select a suitable Base Voltage Range
Low Peak Voltage
 Set the
Base Voltage Range
the
 Set the High Peak Voltage
Base Voltage Range
 Select a suitable Waveform
Waveform
, but others are available.
 Source Resistance
Select a suitable
Frequency
 Select a suitable
Scan Profile
The is now complete, and you can save and exit by clicking the

b) Copying a scan profile

To copy a profile select it from the profile list and click the
Scan Profile
name. Select the profile in the profile list and it is then possible to change the properties of the profile. You can
save and exit by clicking the

c) Editing a scan profile

To edit a profile select the profile in the profile list and it is then possible to change the properties of the profile. You can save
OK
and exit by clicking the
User
Note only profiles can be edited, if you wish to edit a

d) Deleting a scan profile

To delete a profile select the profile in the profile list and click the Delete button. This will remove the profile from the list. A
scan profile cannot be deleted if at least one device in the library is using it.
Note that the profile is not permanently removed until the
Copyright © 2012 - 2017 ABI Electronics Ltd
Add
button to create a blank profile called "
– Usually something that describes this profile's intended use to a user.
from the list, for the device(s) you are going to test.
– This is the lowest voltage used during the scan, and can be any value which is within
.
– This is the highest voltage used during a scan, and can be any value which is within the
.
type from the list, for the device(s) you are going to test – We recommend using a
from the list, for the device(s) you are going to test.
from the list, for the device(s) you are going to test.
OK
button or continue to editing profiles.
button, or you can edit another profile.
New Profile
OK
button or continue to editing profiles.
Copy
button to create a blank profile called "
System
profile you must first make a copy of it.
OK
button is clicked.
". Select the profile in the profile list and
Copy of
Sine
" your selected
Page 21