AVPro Edge AC-SC2-AUHD-GEN2 Quick Start Manual

The ultimate toolbox: 18gbps signal manager, up/down scaler, edid manager, audio de-embedder

Hide thumbs Also See for AC-SC2-AUHD-GEN2:

AC-SC2-AUHD-GEN2

The Ultimate Toolbox: 18Gbps Signal Manager, Up/Down Scaler, EDID Manager, Audio De-Embedder

Quick Start Guide

The AVPro Edge's AC-SC2-AUHD-GEN2 is the ideal solution for integrators that are

needing to distribute a signal to a variety of displays and keep an optimal picture.

Integrators will enjoy it's versatility of not only being able to control up/down

scaling but han¬dling EDID issues (including 4K HDR EDID's) and being able to access

audio from the stream. This scaler is ready for future content as well as it's able

to distribute 18Gbps signaling. Yet if you have 480, 720, or 1080 displays the AC-SC2-

AUHD-GEN2 will make sure it's getting the right picture.

This Quick Start Guide Will be going over:

-Installation

-Control

-Test Pattern

Installation

1. Connect the SC2 Gen 2 to the power source

2. Connect the Source to the "HDMI in" on the sc2 via hdmi cable

3. Connect the display to the "HDMI Out" on the sc2 via HDMI cable

Table of Contents

Do you have a question about the AC-SC2-AUHD-GEN2 and is the answer not in the manual?

Page 1 The Ultimate Toolbox: 18Gbps Signal Manager, Up/Down Scaler, EDID Manager, Audio De-Embedder Quick Start Guide The AVPro Edge’s AC-SC2-AUHD-GEN2 is the ideal solution for integrators that are needing to distribute a signal to a variety of displays and keep an optimal picture.
Page 2 (as shown below), and plug the usb end into any computer Output timing The AVPro Edge’s AC-SC2-AUHD is the ideal solution for anyone that is needing to distribute a signal to a variety of displays and keep an optimal picture. be able to control up/down scaling and also handle EDID issues (including 4K HDR EDID’s), image...
Page 3 To control the output timing press the output setup button until the led is lit at the corrisponding setting numbers. if you have 480, 720, or 1080 displays the AC-SC2-AUHD will make sure it’s getting the right picture with adaptive mode. Signals below 1080p 60Hz get upscaled to 1080p 60Hz, while signals above 1080p 60Hz are bypassed by the scaler.
Page 4 Troubleshooting •Verify Power - When power is applied all lights on the top of the device will flash. You can also pressany of the 3 buttons on the side to change settings, the corresponding lights should change if the unitis powered up. •Verify Connections - Make sure all connected cables are prop- erly connected.