Advertisement
RIVAGE PM Editor (hereinafter referred to as "PM Editor") is a software program that allows you to preconfigure the
RIVAGE PM system on your computer (offline editing) and to monitor or operate the RIVAGE PM system (online
monitoring/operation).
Connecting the RIVAGE series control surface and a computer with PM Editor to the RIVAGE PM system
simultaneously allows you to control the system from both units. Even if you cannot continue to control the system
due to a problem with a control surface, you can still use PM Editor to control the mixing parameters in the RIVAGE
PM system.
Precautions for Use
• For RIVAGE PM Editor earlier than V2.0.0, only one PM Editor can be used per system. RIVAGE PM Editor V2.0.0
or later allows use of up to two per system. Do not connect computers exceeding the usable number.
When you are using two PM Editors for one system, connect the computers to each NETWORK connector of the
DSP engine and the console surface or connect the computers via the switching hub.
• If you synchronize PM Editor with DSP-R10/CSD-R7, any "RECALL UNDO" that was enabled until that point is
reset.
Step 1 Installation and Network Configuration
1
Check whether you can use PM Editor on your computer.
2
Install PM Editor.
(Page
3
Configure the network.
Step 2 Connection and Activation
Connect your computer to the RIVAGE PM system, and launch PM Editor.
RIVAGE PM Editor has the same functions as the touchscreen of the control surface.
For information regarding operations other than the ones described above, refer to the Operation Manual of the
RIVAGE PM series.
You can download the RIVAGE PM Operation Manual from the following website.
https://www.yamaha.com/proaudio/
RIVAGE PM Editor Installation Guide
About RIVAGE PM Editor
How to Start Using the Software
4)
(Page
5)
(Page
4)
(Page
6)
3
Advertisement
