modway EEI -2226 Quick Start Manual

modway EEI -2226 Quick Start Manual

Chair

Advertisement

EEI –2226/2227
Thank you for purchasing the MODWAY CHAIR!
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of small children.

Component:

1
Chair Body
x1
Customer Service 908-368-1025︱www.modwayfurniture.com
CHAIR
2

Hardware:

A
B
C
D
1
Bolt M6x45mm
x 4
Spring Washer M6
x 4
Flat Washer M6
x 4
Allen Wrench
x 1
2
Bottom Base
x1
Page 1 of 2

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EEI -2226 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for modway EEI -2226

  • Page 1 EEI –2226/2227 CHAIR Thank you for purchasing the MODWAY CHAIR! Before you start, here is some helpful advice: 1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step instructions. 2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for.
  • Page 2 EEI –2226/2227 CHAIR STEP 1: Please put Chair Body (1) upside down on a carpeted or padded area. Place Bottom Base (2) to bottom of the Chair Body (1) as shown. Attach by using 4 pieces of Bolt (A), 4 pieces of Spring Washer (B) and 4 pieces of Flat Washer (C). Use Allen Wrench (D) to tighten all Bolts (A) clockwise until secure.

This manual is also suitable for:

Eei -2227Eei-2227-azuEei-2227-beiEei-2227-brnEei-2227-graEei-2227-grn ... Show all

Table of Contents