Control Panel - DCG VERI50 Instruction Manual

FUNCTIONS

CONTROL PANEL

OPERATING INSTRUCTION
1. Filling Water
Pull the back water tank, then use the water container or water pipe to fill up the
water tank until the water is nearly full of water tank. Caution: Do not fill up the water
exceed maximum water scale to avoid the water spilling out while moving the air
cooler.
How to use the functions
2.
ON/OFF
-
Press ON/OFF button
light is illuminated. Press this icon again to turn it off and its Red light is illuminated.
Red light shows when the water tank is empty. Blue light shows when there is water in
the tank.
- FAN SPEED
Press LOW button
button on the Control Panel to adjust wind speed to high.
- COOL
Enter the COOL mode by pressing COOL button
the COOL mode, press COOL button
COOL mode.
REMARKS: When the COOL mode is activated, the pump inside the water tank will
pump water to saturate the cooling pads. Heat that flows through the cooling pad will
exchange with the water and cool the air flowing through the cooling pad to lower the
temperature. Therefore, a decrease in temperature depends on relative humidity and air
temperature when the unit is in Cool mode.
dcg16.it
Instruction manual
on the Control Panel to turn on the air cooler and its Blue
on the Control Panel to adjust wind speed to low. Press HIGH
again. The system will automatically exit the
on the control panel. To turn off
EN