Table of Contents
Advertisement
The wireless roast probe antenna on the top right of the oven
interior is at risk of damage when sliding the FlexiClips with wire rack
in at level 6. Only use the FlexiClips with wire rack at levels 1 to 5.
The following applies to stainless steel surfaces:
Adhesives will damage the coated stainless steel surface and cause
it to lose its dirt-repellent protective coating. Do not use sticky notes,
adhesive tape, or other types of adhesive on the stainless steel surface.
Magnets can cause scratches. Do not use the stainless steel
surface as a magnetic notice board.
Cleaning and care
Only clean parts listed in these operating and installation
instructions.
There is a delicate fiberglass seal around front of the oven
compartment provide a seal for the glass on the inside of the oven
door. This can be damaged by rubbing or scouring. If possible,
refrain from cleaning this.
Do not use oven cleaners. Do not use standard oven cleaners in
the oven compartment or on the front of the oven. Never line the
oven with oven liners.
Risk of injury due to electric shock. The steam from a steam
cleaning appliance could reach live electrical components and cause
a short circuit. Never use a steam cleaner for cleaning.
Scratches on the door glass can cause the glass to break. Do not
use abrasive cleaners, hard sponges, brushes, or sharp metal tools
to clean the door glass.
The side runners can be removed (see "Cleaning and care of the
oven – Removing the side runners"). Reinstall the side runners correctly.
Coarse soiling in the oven compartment can cause thick smoke to
develop. Remove coarse soiling from the oven compartment before
running the Self Clean program.
IMPORTANT SAFETY INSTRUCTIONS
15
Advertisement
Table of Contents
