Charging Operation; Connect Charger To Ev; Start Charging & Stop Charging; Troubleshooting - Verde VER-EVC-7 User Manual

2.3 Charging Operation

2.3.1 Connect Charger to EV

Park EV near to the charger and plug its charging gun into the EV. After charger is
plugged-in, please check the gun is correctly and tightly connected. With
appropriate connection, the charger LED indicator will change to a flashing yellow
light, which indicates that the charger is ready for charging but not charging.
2.3.2 Start Charging & Stop Charging
After the charger is connected to EV and ready for charging, scan the RFID card once
on the identification area of front panel.

3 Troubleshooting

3.1 Indicator State
State
In the standby
Charging status
Plugged gun state
Software upgrade
Ground warning
Relay adhesion
Input polarity
reverse
CP fault
Leakage current
fault
Input terminal
overtemperature
Relay
overtemperature
Under voltage fault
Description
Normal
Normal
Normal
Normal
Normal
Fault
Flashing red, 500ms on, 500ms off, 1 time, 3S
Fault
Flashing red, 500ms on, 500ms off, 2 times,
Fault
Flashing red, 500ms on, 500ms off, 3 times,
Fault
Flashing red, 500ms on, 500ms off, 4 times,
Fault
Flashing red, 500ms on, 500ms off, 5 times,
Fault
Flashing red, 500ms on, 500ms off, 6 times,
Fault
- 11 -
LED Status
Flashing green, 1S on, 3S off
Breathing green, 1S on, 1S off
Green light normally on
Green light flash
Flashing yellow, 2S on, 2S off
Red light normally on
off, Cycle
3S off, Cycle
3S off, Cycle
3S off, Cycle
3S off, Cycle
3S off, Cycle