Garmin GPSMAP 3006C Installation Instructions Manual page 12

I I
NSTALLATION NSTRUCTIONS
Marine Video Cable
The GPSMAP 3006C/3010C Marine Video 17-pin cable allows input of NTSC (National Television System Committee)/PAL (Phase Alternate
Line) composite video sources, and VGA resolution PC monitor output. Marine Video inputs are only available on the MFD to which they are
attached and will not transmit over the Garmin Marine Network. A pinout of the cable is provided below.
1 & 2. VIDEO 1 and VIDEO 2 Inputs (RCA connectors) allow you to input two separate NTSC/PAL compatible video devices, such as
VCR, DVD, TV, or a video camera. The MFD can display one video input at a time or alternate between the two (see the
GPSMAP 3006C/3010C Owner's Manual). Sound from a video source must be attached to a separate stereo/audio system. The video
output from video device attaches to the Video 1 (Black Cable) or Video 2 (Gray Cable) RCA connectors.
3. PC Monitor VGA Output (HD 15-pin connector) for remote viewing of the MFD display on a computer monitor. The remote monitor
must be at least VGA resolution and have multi-sync capability.
4. Tape off any unused wires.
5. Marine Video 17-pin cable attaches to the back of the MFD.
2
1
Marine Video Cable
10
3
4
IMAGE
1
2
3
5
4
2
6
11 10
15
17
Marine Video Cable End View
CONNECTOR PIN #
RCA-1 CENTER 2
RCA-1 OUTER 6
RCA-2 CENTER 11
RCA-2 OUTER 15
HD-15 PIN 1 1
HD-15 PIN 2 4
HD-15 PIN 3 3
HD-15 PIN 4
HD-15 PIN 5 13
HD-15 PIN 6 8
HD-15 PIN 7 8
HD-15 PIN 8 8
HD-15 PIN 9
HD-15 PIN 10 13
HD-15 PIN 11
HD-15 PIN 12
HD-15 PIN 13 7
HD-15 PIN 14 12
HD-15 PIN 15
HD-15 SHELL 9
WIRE- BLACK 5
WIRE- STRIPED 10
1
5 4 3
7
9 8
14 13 12
16
FUNCTION
VIDEO 1 IN (BLACK JACKET)
VIDEO 1 IN, GROUND
VIDEO 2 IN (GRAY JACKET)
VIDEO 2 IN, GROUND
VGA, ANALOG-RED
VGA, ANALOG-GREEN
VGA, ANALOG-BLUE
VGA, ANALOG-GROUND
VGA, ANALOG-RED, GND
VGA, ANALOG-GREEN, GND
VGA, ANALOG-BLUE, GND
VGA, SYNC-GROUND
VGA, H-SYNC
VGA, V-SYNC
VGA, OVERALL SHIELD
NOT USED
NOT USED
GPSMAP 3006C/3010C & GPS 17