Advertisement
Never operate this machine without the feed
GB
hopper or discharge chute properly attached.
Operating Zone
Feeding Materials
Feed only clean materials into the machine.
Foreign matter such as soil, sand, grit, stones,
pieces of metal, etc. will damage the sharp
edge of the cutting knives. Root balls and
dead wood will also dull the blades quickly.
Avoid feeding pine needles, flax and cabbage
tree leaves into the machine; these stringy
materials can wrap around the rotor shaft and
work their way into the bearing.
Avoid feeding short, stubby pieces of wood
into the machine; they tend to bounce and
spin in the feed hopper. Feed these short
pieces together with longer pieces. After
becoming familiar with the machine, prune to
suit its capabilities.
This machine is self-feeding, do not force
branches into the blades. Allow the machine
to automatically feed through. Allow time for
the machine to reach the highest spinning
revolutions before feeding the next load of
branches.
Unclogging
Never allow processed material to build up in
the discharge area. This can prevent proper
discharge and result in kickback from the
chipper hopper.
Never attempt to unclog either the feed
hopper or discharge chute while the engine
WOOD CHIPPER
6
36087UK00M100-出货版_更新回收处理标志.indd 6
is running. Immediately shut off the engine,
allow the cutting disk to come to a complete
stop, and then remove the clogged material.
Inspect for damage and check for any loose
parts for repair or replacement.
Whenever you leave the operating position
or if you have to remove processed material,
leaves, or debris from the machine, always
shut down the engine, and ensure the engine
is switched to "off" to prevent accidental
starting, and wait for all moving parts to come
to a complete stop.
Before opening the cutting disk housing,
always make sure the engine is switched off,
the cutting disk is at a complete standstill, and
the belt drive is disengaged.
Moving
Move the machine at least 10 feet away from
the refueling point before starting engine.
This chipper shredder is for movement by
hand only. Never attempt to tow the machine
on public highways, roads, or thoroughfares.
Always stop the engine before moving the
machine, and watch out for sharp objects that
could pierce the tires.
Machine Use and Care
Position the machine in such a way that it
can not move during maintenance, cleaning,
adjustment, assembly of accessories or spare
parts, as well as under storage.
Do not force the machine. Use the correct
machine for your application. The correct
machine will do the job better and safer at the
rate for which it is designed.
Do not change the engine governor settings
or over-speed the engine. The governor
controls the maximum safe operating speed
of the engine.
Do not run the engine at a high speed when
you are not working.
Do not put hands or feet near rotating parts.
This machine has two rotating cutting knives
capable of amputating hands and feet and
throwing objects. Keep hands and feet out of
openings while machine is running. Failure to
observe these safety instructions could result
in serious injury or death.
2019/10/22 16:17:38
Advertisement
