Advertisement
Gear Selection Lever
The gear selection lever has 4 positions: 3
forward speeds and 1 reverse. To change
speeds, move the speed shift lever to the
desired position. The lever locks in a notch at
each speed selection.
Always release the clutch control
lever before changing speeds.
F a i l u r e t o d o s o w i l l r e s u l t i n
damage to the power trackbarrow.
Slower speeds are for heavier loads, while
faster speeds are for transporting light loads
or an empty hopper. It is recommended that
you use a slower speed until you are familiar
with the operation of the power trackbarrow.
If the engine slows down under a load or the
tracks slip, shift the machine into a lower gear.
If the front of the machine rides up, shift
the machine into a lower gear. If the front
continues to ride up, lift up on the handles.
Left/Right Steering Lever
Operate the lever to turn left/right.
Operate the steering levers only at
a reduced speed.
Engine On/Off Switch
The engine switch has two positions. OFF -
engine will not start or run. ON - engine will
start and run.
Recoil Starter Handle
The recoil starter handle is used to start the
engine.
Fuel Shut-Off Valve
The fuel shut-off has two positions:
CLOSED (
) - Use this position to service,
transport, or to store the unit.
OPEN (
) - Use this position to run the unit.
36087UK00M100-出货版_更新回收处理标志.indd 13
Throttle Control
The throttle control regulates the speed of the
engine, and moves between FAST
, and STOP positions.
The throttle control will shut off the engine
when it is moved to the STOP position.
Choke Control
The choke control is used to choke the
carburetor and assist in starting the engine.
The choke control slides between the CHOKE
CLOSED
and CHOKE OPEN
Never use choke to stop engine.
Clutch Control Lever
Squeeze the control lever, clutch engaged.
Release the lever, clutch disengaged.
Feed Hopper
The feed hopper is where you insert your
materials to be chipped.
Discharge Chute
Chipped materials are discharged through this
opening. The deflector can be attached to the
chute.
Engine On/Off Switch
The engine switch has two positions. OFF -
engine will not start or run. ON - engine will
start and run.
Recoil Starter Handle
The handle is used to start the engine.
Fuel Shut-Off Valve
The fuel shut – off has two position. CLOSED
(
) - use this position to service, transport,
or store the unit.
OPEN (
) - use this position to run the unit.
Choke Control
The choke control is used to choke the
, SLOW
positions.
WOOD CHIPPER
2019/10/22 16:17:58
GB
13
Advertisement
