Advertisement
Preparing to Install the Kit
Washing the Machine
Important:
Before installing this kit, you
must thoroughly clean the machine to avoid
contaminating the hydraulic system—a clean
machine is required.
Wash the machine; refer to washing the machine in
the Operator's Manual for your machine.
Preparing the Machine
1.
Park the machine on a level surface.
2.
Lower the cutting units.
3.
Engage the parking brake.
4.
Shut off the engine and remove the key.
5.
Wait for all moving parts to stop.
6.
Allow the engine to cool completely.
Opening the Hood
Models 31654
Unlatch and open the hood.
Removing the Storage
Compartment
Models 31657 and 31659
1.
At the left side of the operator's platform, open
the door of the storage compartment
1. Washer
2. Knob
(Figure
Figure 1
3. Storage compartment
2.
Remove the 3 knobs and 3 washers that secure
the storage compartment to the machine, and
remove the compartment
Disconnecting the Battery
1.
Loosen the forward nut of the negative
battery-cable terminal
1. Nut (negative
battery-cable terminal)
2.
Lift the negative battery cable from the battery
post
(Figure
Note:
Position the negative-battery cable where
it cannot contact the negative battery post.
1).
g328513
2
(Figure
1).
(Figure
2).
Figure 2
2. Negative battery post
2).
g344733
Advertisement
