Advertisement
1.
Disconnect the mains adapter (3) from
the device.
2. Push the cleaning attachment (5) as far as
it will go into the suction opening (6).
3. Attach the cleaning cloth (1) to the cleaning
attachment (5) using the Velcro fastener.
4. Fill the measuring cup (4) with water and a
little window cleaning agent if necessary.
5. Pull the sealing cap (15) out of the fresh
water tank (16).
6. Hold the device horizontally and pour the
liquid from the measuring cup (4) into the
opening of the fresh water tank (16).
CAUTION: Do not pour more than 50 ml
(one full measuring cup (4)) into the fresh
water tank (16).
7. Push the sealing cap (15) as far as it will go
into the opening of the fresh water tank
(16).
8. Spray the surface which is to be cleaned:
Hold the device vertically with the cleaning
attachment (5) at the top, direct the spray
nozzle (14) towards the surface and press
the Spray Trigger (8).
9. Turn the device around, spread the liquid
with the cleaning cloth (1) and dissolve
the dirt.
10. Turn the device around again and switch
on the suction function:
Press the
On/Off switch (7).
8
11. Hold the device by the handle (9), place
the scraper lip (20) on the wet surface
and pull it up and down by applying gentle
pressure. Hold the device vertically and do
not press it on too firmly!
To prevent streaks from forming, do not
allow water residues to dry in the air.
Do not leave the suction function constantly
switched on so that the battery charge lasts
for as long as possible.
12. Once the MAX marking of the dirty water tank (17) has been reached,
switch off the device by pressing the
dirty water tank (17) (see the "After Use / Cleaning the Device and
Accessories" chapter). Then continue cleaning.
•
Charge up the battery when the performance of the device diminishes
(see the "Charging Up the Battery" chapter).
After Use / Cleaning the Device and Accessories
• Empty both water tanks after each use of the device to prevent deposits in
the water tanks and any damage to the device resulting from this!
• Never immerse the motor unit in water or other liquids to avoid an electric
shock!
• Do not use any sharp or abrasive cleaning agents or cleaning pads. These
could damage the surfaces.
1. Detach the cleaning cloth (1) from the cleaning attachment (5) and wash it
in accordance with the specifications on the washing label.
2. Empty the dirty water tank (17) and, if there is heavy soiling, rinse it out:
– Pull out its sealing cap (18) and allow all the remaining water to run into
a drain.
– Then reinsert the sealing cap (18).
3. Open the fresh water tank (16) and empty it completely.
4. Pull the cleaning attachment (5) off the motor unit (2), then rinse it using
clear water.
5. Wipe down the motor unit (2) if necessary with a soft, damp cloth and
then dry it with a soft cloth.
6. Allow all parts to dry in the air before storing away the device. Leave the
water tanks (16, 17) open to prevent mould from forming.
7. Charge up the battery after each use (see the "Charging Up the Battery"
chapter).
8. Store the device in a dry, cool indoor room out of the reach of children
and animals.
On/Off switch (7) and empty the
9
Advertisement
