Advertisement
Device Overview
6 Suction opening
7
On/Off switch
8 Spray Trigger
9 Handle
10 Charge control lamp
11 Mains adapter connecting socket
12 Ventilation openings
13 Blind hole (no function)
14 Spray nozzle
15 Sealing cap of the fresh water tank
16 Fresh water tank
17 Dirty water tank
18 Sealing cap of the dirty water tank
19 Base
20 Scraper lip
Before Initial Use
!
CAUTION!
• Keep children and animals away from the packaging material. There is a
danger of suffocation, among other dangers!
1. Unpack all parts and check the items supplied for completeness (see the
"Items Supplied" chapter) and possible transport damage. If you find any
damage to the components, do not (!), use the device but contact our
customer service department.
2. Before using the device, remove all packaging materials and any labels that
may be on the device and are used for protection during transportation or
for advertising.
3. Fully charge up the battery (see the "Charging Up the Battery" chapter).
13
8
12
20
19
6
Charging Up the Battery
!
CAUTION!
6
• Charge the battery only with the mains adapter (3) supplied with it. Do not
use the mains adapter (3) to charge up other batteries.
7
• The battery must not be taken apart, thrown into a fire, immersed in liquids
or short-circuited.
9
• It is essential that you charge up the battery fully (approx. 4 to 5 hours)
before you first use the device in order to achieve the maximum charging
10
capacity. If the battery is fully discharged during use, it must be fully charged
11
up again before it is next used.
1. First plug the barrel connector on the cable
of the mains adapter (3) into the connecting
14
socket (11) and then connect the mains
adapter (3) to an easily accessible
plug socket.
15
16
2. The charge control lamp (10) will turn red
indicating the battery is being charged.
17
18
3. After 4 to 5 hours, when the battery is fully charged, the charge control lampl
(10) will turn green. Disconnect the the mains adapter (3) from the mains
power and then disconnect the barrel connector from the motor unit (2).
Use
!
CAUTION!
• The device should be positioned parallel to the window at 90 degrees,
using a vertical, top to bottom motion. You may use a horizontal motion at
90 degrees but do not turn the device upside down 180 degrees.
• Only ever pour conventional window cleaning agents into the fresh water
tank! Do not use any spirit or foam cleaning agents as they can interfere
with the way the device works.
• Do not pour boiling-hot water into the fresh water tank. The water must be
no hotter than 40°C.
• Do not open either of the two water tanks during use!
• Empty the dirty water tank after each use or when the MAX marking is
reached (see the "After Use / Cleaning the Device and Accessories"
chapter). IMPORTANT: Do not overfill the dirty water tank!
• Do not use the device when it is connected to the mains power supply.
7
Advertisement
