Battery Charger Error Codes - Club Car Tempo 2020 Maintenance And Service Manual

BATTERY CHARGER

BATTERY CHARGER ERROR CODES

The "E" codes will appear in the display panel followed by three numbers and a period to indicate the different
conditions.
_
ERROR CODES
Reverse polarity error
E-0-1-2
Possible Cause:
• Battery is connected the wrong way around
Battery does not take current
Possible Cause:
• Electrical device connected between the battery charger
E-0-1-3
and the battery, which passes through voltage but not cur-
rent
• Error in the BMS/VCM software configuration
USB operation failed (software)
E-0-1-3
E-0-1-8
Possible Causes:
E-0-2-6
• USB flash drive not formatted correctly
E-0-1-7
USB operation failed (hardware)
E-0-2-7
Algorithm error
E-0-2-0
Possible Cause:
E-0-2-8
• The algorithm is not compatible with the software version
High AC voltage error (>270VAC)
E-0-2-3
Possible Cause:
• AC power source voltage is too high
E-0-2-4 Charger failed to turn on properly
TABLE CONTINUED ON NEXT PAGE
DESCRIPTION
Tempo, Tempo Connect, and Tempo 2+2 Maintenance and Service Manual
Battery Charger Troubleshooting
SOLUTIONS
This error will automatically clear once the condition has been
corrected.
1. Make sure that the battery wires are connected correctly.
This error will automatically clear once the battery charger
power is reset.
1. Reset the battery charger power.
2. If problem continues, contact Club Car.
This error will automatically clear once the battery charger
power is reset.
1. Make sure the USB flash drive is correctly formatted and
not corrupted.
2. Try to update the battery charger again.
This error will automatically clear once the battery charger
power is reset.
1. Remove and install the USB flash drive.
2. Disconnect the AC cord from the power source for a min-
imum of 30 seconds.
3. Try to update the battery charger again.
This error will automatically clear once the battery charger
power is reset.
1. Install the latest software and algorithm.
2. Select the correct algorithm.
This error will automatically clear once the condition has been
corrected.
NOTE: The dash display will display SERVIC. Vehicle fault
code 77 will automatically clear once the condition has
been corrected.
1. Connect the battery charger to an AC source that pro-
vides stable AC between 85 - 270 VAC / 45 - 65 Hz.
This error will automatically clear once the battery charger
power is reset.
1. Disconnect the AC input for 30 seconds. Connect the AC
input.
15
Page 15-19