How To Use - Panasonic NI-GT500 Operating Instructions Manual

How to use

First use
1. Remove the label on the product.
2. Set the level adjustment button (for NI-GT500 only) /
temperature selector (for NI-GT200 only) of iron by
following the instructions for "Steam ironing", and then iron
a wet cloth for a few minutes to clear the residue from the
soleplate.
14
Notes:
a. When you use the product for the first time, you may
smell an odor. The odor will disappear naturally after
the product is used for several times. Please rest
assured.
b. When the product is used for the first time, some
particles may appear on the soleplate. This is normal.
The particles are harmless and will disappear after a
short period of time.
c. When the product is started, a sound may be heard,
which is the sound of pumping by the water pump.
This is normal.
d. During heating of the soleplate, a few drops of water
may keep dripping out for about 3 seconds. This is
normal.
e. After the first use, a small amount of condensate water
may appear in the hose. When the product is used
the next time, the condensate water will be ejected
together with steam when steam is ejected from the
soleplate, which will last several seconds. This is
normal.
f. When removing the water tank from the power base,
you will see some drops of water at the position where
the water tank is installed on the power base. This is
normal.
Operating instructions
This product has been designed for dry ironing and steam
ironing.
• Dry ironing
1. Place the iron on the heat-insulation pad of the power base.
2. Connect the power supply. Then a beep is sounded.
3. Press the power button. Then the power indicator turns on.
4.1 For NI-GT500 only:
Press the level adjustment button to set the level
according to materials of clothes (See the section "Fabric
and ironing recommendations"). The corresponding level
indicator and the eco steam level indicator start flashing
and the product starts heating. When the iron finishes
heating, the level indicator will become steady on from
flashing. This indicates that you can start dry ironing.
4.2 For NI-GT200 only:
Press the temperature selector to set the level according
to materials of clothes (See the section "Fabric and ironing
recommendations"). The thermostat indicator turns on,
the eco steam level indicator starts flashing and the
product starts heating. After the iron finishes heating, the
thermostat indicator turns off. This indicates that you can
start dry ironing.
• Steam ironing
1. Place the power base on a stable surface.
2. Take out the water tank and inject water through the water
inlet. It is recommended to use purified water with less
mineral content. The maximum capacity of the water tank is
1.8 L. Please make sure that the "MAX" water level mark is
not exceeded.
3. Place the iron on the heat-insulation pad of the power base.
4.1 For NI-GT500 only:
1 Connect the power supply and press the power button.
The power indicator turns on. Press the level
adjustment button to set the level according to
materials of clothes (See the section "Fabric and ironing
recommendations"). The corresponding level indicator
and the eco steam level indicator start flashing and the
product starts heating.
2 Wait about 2 minutes until the level indicator becomes
steady on from flashing, which indicates that the
soleplate finishes heating. About 3 minutes later, the
steam level indicator becomes steady on from flashing,
which indicates that the power base finishes heating.
Then, you can press the steam button to use steam for
ironing.
∙ Water may leak when the iron sprays steam at the
beginning. Please press the steam level adjustment
button to set the steam level to "QUICK CARE" or rest
the iron on the power base for about 15 seconds.
15