Checking The Piston Pin; Checking The Piston Rings - Yamaha MX250 Service Manual

PISTON, CAMSHAFT, CRANKCASE, AND CRANKSHAFT
a

CHECKING THE PISTON PIN

1.
Check:
• Piston pin
Blue discoloration/grooves  Replace the piston
pin and then check the lubrication system.
2.
Measure:
• Piston pin hole inside diameter "a"
Out of specification  Replace.
Piston pin hole inside diameter:
Limit:
3.
Measure:
• Piston pin diameter "a"
Out of specification  Replace.
Piston pin diameter:
Limit:
a
4.
Check:
• Check that the piston pin enters smoothly into the
piston pin hole.
TIP
If the piston pin fits too tight into the piston, check the pis-
ton pin hole. If there is any protrusion, use a knife or
scraper to gently remove it so that piston pin can be
pushed in smoothly with your fingers.

CHECKING THE PISTON RINGS

The following procedure applies to all of the piston rings.
1.
Measure:
• Piston ring side clearance
Out of specification  Replace the piston and pis-
ton rings as a set.
TIP
Before measuring the piston ring side clearance, eliminate
any carbon deposits from the piston ring grooves and pis-
ton rings.
3-39
19.004–19.015 mm (0.7481–0.7486 in)
19.045 mm (0.7498 in)
18.995–19.000 mm (0.7478–0.7480 in)
18.975 mm (0.7470 in)
1
2
3
4
5
6
7
8
9
10