WMF PERFECTION 800L Series Operating Instructions Manual page 50

FUNCTION
Using
beverages
Using
milk froth
PROBLEM
There is water in coffee
ground retainer.
When you turn off the
appliance, warm water flows
out of the coffee outlets and
the One Touch Cappuccino
block.
The One Touch Cappuccino
block does not suck the milk.
The One Touch Cappuccino
blocks produces little or no
froth.
The milk or water is not
flowing cor ectly into the
cup(s).
There are traces of milk in an
Americano or a Hot water.
The espresso or coffee is not
hot enough.
The coffee is too lightly
coloured or too weak.
CORRECTIVE ACTION
If some water is flowing on the upper cover of the
appliance, this flowing is di ectly conducted to
coffee retainer. Avoid to stack a fully cup on the
top of the appliance.
According to the type of recipe prepared, the
machine may run an automatic rinsing cycle when
it is turned off, to avoid clogging. This cycle lasts
only a few seconds and stops automatically.
Check that the block is assembled correctly (in
particular the connector in the milk tube).
Ensure that the steam nozzle is not blocked. If
this is the case, see below "The steam nozzle on
your machine seems to be partially or completely
blocked". Check that the connector is not blocked
or dirty; soak it in a mixture of hot water and
washing-up liquid, then rinse and dry before
reassembling. Ensure that the flexible pipe is not
blocked or twisted and that it is properly inserted
into the One Touch Cappuccino block in order to
avoid any air leaks. Check that it is fully immersed
in the milk. Rinse and clean the block (see chapters
concerning rinsing and cleaning the One Touch
Cappuccino block).
For milk drinks, we recommend that you use fresh,
pasteurized or UHT milk which has been recently
opened. It is also advisable to use a cold container.
Check that the One Touch Cappuccino block
correctly positioned.
Complete a milk rinsing cycle or dismantle and
clean the One Touch Cappuccino accessory before
running the preparation.
Run a coffee circuit rinsing cycle before preparing
your coffee. Increase the coffee temperature in the
advanced menu or in the settings menu. Warm the
cup by rinsing it with hot water before making the
drink. Choose a cup according the volume of recipe
you request.
Avoid using oily, caramelized or flavou ed coffee
beans. Check that the coffee bean is dispensing
correctly and that nothing is obstructing the
sensor. Decrease the volume of the preparation
and increase the strength of your drink. Push the
grinding fineness adjustment cu sor to the left
to make the grounds fine . Make the drink in two
cycles by using the 2 cups function.
50
is
6