INSTALLATION AND OPERATING CONDITIONS OF THE
Connect to the power supply
•
This appliance should be connected to AC 115V/60Hz supply socket.
•
It is a legal requirement that the appliance is properly grounded. The manufacturer will not be held
liable for any damage or injury which may result from the failure to fulfil this requirement.
•
Do not use adapters, multiple sockets and two-wire extension cords. If it is necessary to use the
extension cord, it must have an appropriate wire gauge and safety certification for the load requirement
of this appliance.
•
When an extension cord is used, it's socket must be located at a safe distance away from sinks and must
not be in a place where it could be flooded by water or wastewater.
•
See the serial plate at the lower part of the internal wall of the appliance for detailed specifications**.
Disconnecting the power supply
•
Make sure the appliance can be easily disconnected from the mains, either by unplugging from the
mains socket, or by switching off the breaker.
Minimum distances from heat sources
•
from electric, gas and other ovens – 1 inch (30 mm)
•
from oil or coal fired ovens – 12 inches (300 mm)
•
from built-in ovens – 2 inches (50 mm)
•
Use an appropriate insulation panel between them when there is no possibility of ensuring the specified
distances.
Installation before using the appliance for the first time
•
Make sure there is enough space around the refrigerator to allow it work properly. A free space of ¼
inch (1cm) is required on the rear of the appliance so that the air can be circulated to cool the
compressor and condenser. And 12 inches (30cm) space above the refrigerator.
•
Make sure the appliance is placed in level position by adjusting the 2 adjustable front legs.
Shelves
The fridge shelves can be moved according to the storage requirements within the fridge section.
To move the shelf, lift up the rear section and then pull it outwards.
To replace, slide the shelf back into the slot, and then lower the rear section.
APPLIANCE
4