Toshiba 28ZH46 Series Owner's Manual page 7

Front connections and controls
A wide variety of external equipment can be connected via the sockets located behind the flap on the
television. Press the centre of the flap to open it.
Whilst all the necessary adjustments and controls for the television are made using the remote control, the
buttons on the television may be used for some functions.
Switching on
If the power-on light is unlit press the POWER button on
the front of the television to switch the television on, then
press a number button on the remote control to see the
screen.
To put the television into Standby press
control. To view the television press
the number buttons. The picture may take a few seconds
to appear. Standby should only be used for short periods
of time.
To set up the television you will now need to use the on-
screen menus. Press the MENU button on the remote
control to see the top menu bar.
This white menu bar will show five different topics shown
in symbols. As each symbol is selected by pressing the
S or R button on the remote control, its respective options
will appear below.
To use the options press the Q button on the remote
control to move down through them and S or R to select
the required choice. Follow the on screen instructions.
The functions of each menu are described in detail
throughout the manual.
on the remote
i
i again or any of
Using the controls and connections
To alter the volume press —
To alter the programme position press
Press MENU and S , R , Q or P to control the sound
and picture options.
Press MENU to finish.
Before connecting any external equipment, turn off
all main power switches.
When connecting mono sound equipment to Input 3,
connect the audio output of the equipment to the
L/Mono socket on the television.
To select the Inputs, press
EXT3 as described on page 16.
Please always refer to the owner's manual of the
equipment to be connected for full details.
Please note: Inserting the headphone jack will mute the
sound from all speakers.
7
GREEN – On timer is set
RED – Power On
Power Button
+
j .
e e f f .
F
B until the display shows