Wall Mounting - Polaris Mercury 5.3OD Manual Instruction

1. The unit should be connected with power supply using a double wire automatic switch.
2. The rated electrical characteristics of automatic switch should not be less than rated electrical
characteristics of the unit.
3. The unit should be grounded safely.
4. Please use current source with 220 V voltage and 50Hz frequency.
5. A protective cutout device should be installed to the power-supply circuit. Please contact
authorized specialists.

Wall mounting

1
1. Affix the mounting plate to the wall and make pencil notes for future holes. Make sure the unit
position is directly vertical.
2. Drill screw holes.
3. Fix elastic inserts into holes for an appropriate fastening.
4. Mount accurately the back panel of the unit on the wall.
5. Install the unit on the mounting plate and fix it with 4 screws.
Wall
2
17
Elastic insert Wall
3