Flash Furniture MK-LCKR001-GG Assembly Instructions

ASSEMBLY INSTRUCTIONS
Before You Begin: Phillips screwdriver (not included) required for assembly
Please identify all component parts and hardware pieces required before you begin. Carefully remove all of the components from the packaging and
set aside for assembly. Assemble on a soft surface to prevent scratching during assembly.
Phillips screwdriver required for assembly (Not Included).
Caution:
Tighten all components securely before use. Failure to do so may result in personal injury. DO NOT use any sharp objects to open plastic wrapped
components as damage to product or componenets may result.
Warning:
!
CHOKING HAZARD - Small Parts. Adult Assembly Required.
DO NOT ALLOW CHILDREN TO CLIMB ON FURNITURE.
The tipping restraint is intended only as a safety measure, it is not a substitute for proper adult supervision.
Serious or fatal injuries can occur from furniture tipping over. You must install Tipping Restraint Hardware (where included) to help prevent the unit
from tipping and causing accidental injury, instability, death or damage. The tipping restraint is intended only as a safety measure,
it is not a substitute for proper adult supervision.
To help prevent furniture from tipping over it must be permanently attached to the wall. Anti-Tip Safety Wall
Straps suitable for the unit weight and wall materials (if not included) should be purchased and installed.
Online Assembly Instruction: http://ftp.flashfurniture.com/AssemblyInstructions/MK-LCKR001-GG.pdf
Customer Service Email: CustomerExperience@belnick.com
MK-LCKR001-GG
Wooden 5 section School Coat Locker with Bench, Cubbies,
and Storage Organizer Hook - Safe, Kid Friendly Design
48"H x 47"L
| Phone: 866-552-2810
WARNING:
!
30 min
CHOKING HAZARD - Small Parts.
Not For Children Under 3 Years.
WARNING:
!
Adult assembly required. This item
contains small parts that have sharp
points and edges in the unassembled
state. Adults must be extra careful to
securely tighten all screws, make
sure the toy is properly assembled,
and ensure there are no left-over
metal parts (eg. Allen key) within
reach of children.