Table of Contents
Advertisement
Version 6
Front extension arms required
Rear extension arm required
Lift range
Maximum Euro-adapter height
Lift capacity (working load) 2 pers. + accessories
Counterweight required for max. load
Counterweight required to balance empty arm
Crane weight (excluding dolly and weights)
Dolly weight (unit weights see page 46)
Arm reach (pivot to camera head mount)
Length of rear end (pivot to outside of bucket)
Continue from § 12, page 6
13. Connect the 200cm / 6' 6" extension number 2 to extension number 1. Slip the
connection flanges into each other and secure with the provided safety pin.
Note:
Section 2 must be supported by a suitable support stand or rostrum.
Tip:
To avoid the sections jamming or getting stuck make sure that the sections
are joined parallel. Using a small amount of lubricant also helps. We suggest
rubbing the joints with an oiled rag prior to assembly.
14. Connect the 200cm / 6' 6" extension number 3 to extension number 2. Slip the
connection flanges into each other and secure with the provided safety pin.
Note:
Move the support stand or rostrum to support section 3.
15. Connect the 100cm / 3' 3" extension to extension number 3. Slip the connection
flanges into each other and secure with the provided safety pin.
16. Connect a 200cm / 6' 6" parallelogram rod to the parallelogram connection on the
middle section and secure it with the provided safety pin.
17. In turn, connect 2 x 200cm / 6' 6" parallelogram rods to the first parallelogram
connection and secure them with the provided safety pins.
Note:
Support the second parallelogram rod with the parallelogram support and
secure with the locking pin.
18. Connect the 100cm / 3' 3" parallelogram rod to the last parallelogram connection and
secure it with the provided safety pin.
19. Connect the angle adjuster to the end of the 100cm / 3' 3" extension. Release the
angle adjuster by removing the safety pins from the side of the angle adjuster. Secure
the angle adjuster to the 100cm / 3' 3" extension with a removed safety pin.
Tip:
The angle adjuster has two sidewise safety pins. These are either used for
the angle adjusters transport position or to secure the connections between
angle adjuster and extension as well as angle adjuster and platform.
20. Connect the 100cm / 3' 3" parallelogram rod to the rod on the angle adjuster and
secure it with the provided safety pin.
Tip:
The angle adjuster has an integrated leveller. By turning it, the vertical plate
on the angle adjuster can be set to a perfect right angle. Correct setting of
the angle adjuster enhances the crane's balance.
GF-16 Crane System Instruction Manual
3 x 200 cm / 6' 6" + 1 x 100 cm / 3' 3"
1 x 192 cm / 6' 3"
1205 cm / 39' 6"
816 cm / 26' 9"
250 kg / 550 lbs
1078 kg / 2371 lbs
266 kg / 585 lbs
806 kg / 1777 lbs
244 kg / 536 lbs
829 cm / 27' 2"
278 cm / 9' 1"
Page: 17
Advertisement
Table of Contents
