Disassembly Procedures, Panaray Model 620M Loudspeaker - Bose Panaray 310M Service Manual

DISASSEMBLY PROCEDURES
Panaray Model 620M
Loudspeaker
Refer to figure at right for the
following procedures.
1. Grille Removal
1.1 Remove the four screws (11)
using a Phillips-head screwdriver.
1.2 Lift off the grille (1).
2. Handle Removal
2.1 Perform procedure 1.
2.2 Remove the two screws (13).
Lift off the handle (3).
3. Woofer Removal
3.1 Perform procedure 1.
3.2 Remove the four screws (12).
3.3 Lift out the woofer (2) and
disconnect the wires from the
terminals.
Re-assembly Notes: Be sure to observe
polarity when connecting the new woofer to
the wiring harness.
4. Tweeter Driver Removal
4.1 Perform procedure 1.
4.2 Remove the four screws (14).
4.3 Lift out the driver (5) and disconnect the
wires from the terminals.
Re-assembly Notes: Be sure to observe
polarity when connecting the new driver to
the wiring harness.
5. Neutrik Speakon
®
5.1 Remove the two screws (15) for the jack
you wish to remove.
5.2 Lift off the input jack (10). Cut the wires
as close to the jack as possible. Refer to the
wiring diagram in the back of this manual
when installing the new jack.
6. Crossover Assembly Removal
6.1 Perform procedure 3.
6.2 Disconnect the crossover harnesses
from the woofer, tweeters and input jacks.
6.3 Remove the four nuts that secure
the crossover assembly (7) to the input
panel (9). Lift out the crossover assembly.
14
Jack Removal
®