Page 1
PA02/PA04 Power Antenna PA02/PA04 Installation Guide The information enclosed in this installation guide is intended to provide a general outline to assist you during the process of installation. This guide does not cover every installation possibility, vehicle, or aspect of the installation process.
Page 2
Installing the Antenna 1. Disconnect the battery before you begin the installation. Make sure the area for the antenna has enough clearance to house the antenna. The PA02 and PA04 antennas require approximately 11 1/2 inches or 29 cm of clearance.
Page 3
Switched wire from radio Flexible mast cable Red (battery +12 volt) wire from 5 amp fuse to red antenna wire White (-) to chassis ground from antenna Fuseblock Fuseblock Motor Assembly Switched Unswitched Metal Strap Battery Ignition switch Drain Tube PA02/PA04...
Page 4
Warranty Your Power Antenna comes with a manufacturer’s warranty covering any defects in materials and workmanship. Retro Manufacturing, LLC (collectively referred to as “the warranter”), at its option, will either (a) repair your unit with new or refurbished parts or (b) replace it with a new or refurbished unit. The warranty period starts from the original purchase date and is valid for the length of time indicated in the chart below.
Need help?
Do you have a question about the PA02 and is the answer not in the manual?
Questions and answers