Table of Contents
Advertisement
FLOOR-STANDING TYPE AIR CONDITIONER
Owner's Manual &
Installation Manual
FPA-400IGM
FIP-400M
IMPORTANT NOTE:
Read this manual carefully before installing or operating
•
your new air conditioning unit. Make sure to save this
manual for future reference.
•
Please check the applicable models, technical data, F-GAS (if any)
and manufacturer information from the "Owner's Manual - Product
Fiche " in the packaging of the outdoor unit.
(European Union products only)
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for FUJIDENZO FPA-400IGM
Summary of Contents for FUJIDENZO FPA-400IGM
- Page 1 FLOOR-STANDING TYPE AIR CONDITIONER Owner’s Manual & Installation Manual FPA-400IGM FIP-400M IMPORTANT NOTE: Read this manual carefully before installing or operating • your new air conditioning unit. Make sure to save this manual for future reference. • Please check the applicable models, technical data, F-GAS (if any) and manufacturer information from the “Owner's Manual - Product...
-
Page 2: Table Of Contents
Table of Contents Safety Precautions .................04 Owner’s Manual Unit Specifications and Features...........08 1. Unit Parts ..........................08 2. Operating temperature......................08 3. Features ............................09 Manual Operations.................10 Care and Maintenance..............15 Troubleshooting................17... - Page 3 Installation Manual Accessories ...................20 Installation Summary ..............21 Unit Parts ..................22 Indoor Unit Installation ...............23 1. Select installation location ....................23 2. Unfastening the operation panel and detaching the filter .............24 3. Remove the fasteners from the roller ...................24 4. Fastening the indoor unit ....................24 5.
-
Page 4: Safety Precautions
Safety Precautions Read Safety Precautions Before Operation and Installation Incorrect installation due to ignoring instructions can cause serious damage or injury. The seriousness of potential damage or injuries is classified as either a WARNING or CAUTION. CAUTION WARNING This symbol indicates the possibility of This symbol indicates the possibility property damage or serious consequences. - Page 5 CLEANING AND MAINTENANCE WARNINGS Turn off the device and disconnect the power before cleaning. Failure to do so can cause • electrical shock. Do not clean the air conditioner with excessive amounts of water. • Do not clean the air conditioner with combustible cleaning agents. Combustible cleaning agents •...
-
Page 6: Owner's Manual
WARNINGS FOR PRODUCT INSTALLATION 1. Installation must be performed by an authorized dealer or specialist. Defective installation can cause water leakage, electrical shock, or fire. 2. Installation must be performed according to the installation instructions. Improper installation can cause water leakage, electrical shock, or fire. (In North America,installation must be performed in accordance with the requirement of NEC and CEC by authorized personnel only.) 3. - Page 7 WARNING for Using R32/R290 Refrigerant When flammable refrigerant are employed, appliance shall be stored in a well -ventilated area where the room size corresponds to the room area as specified for operation. For R32 frigerant models: Appliance shall be installed, operated and stored in a room with a floor area larger than X m²...
-
Page 8: Unit Specifications And Features
Unit Specifications and Features Unit Parts Air outlet Display panel Operating temperature When your air conditioner is used outside of the following temperature ranges, certain safety protection features may activate and cause the unit to disable. Inverter Split Type FOR OUTDOOR UNITS COOL mode HEAT mode DRY mode... -
Page 9: Features
Fixed-speed Type COOL mode DRY mode HEAT mode 0°C-30°C Room 17°C-32°C (62°F-90°F) 10°C-32°C (50°F-90°F) Temperature (32°F-86°F) 18°C-43°C (64°F-109°F) 11°C-43°C (52°F-109°F) -7°C-43°C (19°F-109°F) -7°C-24°C Outdoor 18°C-43°C (64°F-109°F) (For models with low-temp cooling systems) Temperature (19°F-75°F) 18°C-52°C (64°F-126°F) 18°C-52°C (64°F-126°F) (For special tropical models) (For special tropical models) NOTE: Room relative humidity less than 80%. -
Page 10: Manual Operations
Manual Operations NOTE: Different models have different display panel. Not all the indicators describing below are available for the air conditioner you purchased. Please check the indoor display panel of the unit you purchased. Illustrations in this manual are for explanatory purposes. The actual shape of your indoor unit may be slightly different. - Page 11 Auto operation display Auto operation Cooling operation display Heating operation Dry operation display Cooling operation Heating operation display Fan operation Fan operation display Dry operation Lock operation display Lock operation Swing operation display On timer operation display Sleep operation display Off timer operation display Turbo operation display Turbo operation display(optional)
- Page 12 Fan button: This button is used to select the desired fan speed. Each time you push the button, the fan speed is shifted in the following sequence: MED (some units) HIGH AUTO Fan speed display: Third Fan Speed Symbol Second Fan Speed Symbol First Fan Speed Symbol The low-frequency flashing cycle of the three fan speed symbols indicate low fan or Auto fan.
- Page 13 AUXILIARY FUNCTION button（some models）: Use this button to select or cancel the auxiliary feature. Press this button, then press the " " " " or " " " " button to select the desired feature. Each time the button is pressed, the mode is shifted in the direction of the arrow: If press "...
- Page 14 Airflow Direction Control Horizontal Airflow Direction (AUTO) The Left/Right(Horizontal Airflow) can be adjusted by using the remote control or unit control. Press the"AUXILIARY FUNCTION" button on the unit control panel, then press the ADJUST " " and " " button to select the " "...
-
Page 15: Care And Maintenance
Care and Maintenance Cleaning Your Indoor Unit CAUTION BEFORE CLEANING OR • Do not use water to clean the inside of MAINTENANCE the indoor unit. This can destroy ALWAYS TURN OFF YOUR AIR CONDITIONER insulation and cause electrical shock. SYSTEM AND DISCONNECT ITS POWER SUPPLY •... - Page 16 Refrigerant Leak Detection System (some Maintenance – models) Pre-Season Inspection In the event of a refrigerant leak, the LCD • screen will display “EC” or “EH0C”(Model After long periods of non-use, or before periods dependent). of frequent use, do the following: Maintenance –...
-
Page 17: Troubleshooting
Troubleshooting SAFETY PRECAUTIONS If any of the following conditions occurs, turn off your unit immediately! The power cord is damaged or abnormally warm • You smell a burning odor • The unit emits loud or abnormal sounds • A power fuse blows or the circuit breaker frequently trips •... - Page 18 Issue Possible Causes The outdoor unit The unit will make different sounds based on its current operating mode. makes noises Dust is emitted from The unit may accumulate dust during extended periods of non-use, which will be either the indoor or emitted when the unit is turned on.
- Page 19 Problem Possible Causes Solution Wait for the power to be restored Power failure The power is turned off Turn on the power The unit is not The fuse is burned out Replace the fuse working Replace batteries Remote control batteries are dead The Unit’s 3-minute protection Wait three minutes after restarting has been activated...
-
Page 20: Accessories
Accessories The air conditioning system comes with the following accessories. Use all of the installation parts and accessories to install the air conditioner. Improper installation may result in water leakage, electrical shock and fire, or cause the equipment to fail. The items are not included with the air conditioner must be purchased separately. -
Page 21: Installation Summary
Installation Summary - Indoor Unit INSTALLATION ORDER Install the indoor unit Install the outdoor unit Connect the refrigerant pipes Perform a test run Evacuate the refrigeration system Connect the wires Page 21 ... -
Page 22: Unit Parts
Unit Parts Outdoor unit Indoor unit Air outlet Drain pipe, vent pipe Operation panel Connection cable Horizontal airflow control louver Connection pipe Vertical airflow control louver Refrigerant pipe port Air inlet(2 sides) Air outlet NOTE ON ILLUSTRATIONS Illustrations in this manual are for explanatory purposes. The actual shape of your indoor unit may be slightly different. -
Page 23: Indoor Unit Installation
Indoor Unit Installation Installation Instructions – Indoor unit NOTE ABOUT WALL HOLE: If there is no fixed refrigerant piping: PRIOR TO INSTALLATION While choosing a location, be aware that you should leave ample room for a wall hole (see Before installing the indoor unit, refer to the Drill wall hole for connective piping step) label on the product box to make sure that the for the signal cable and refrigerant piping... -
Page 24: Unfastening The Operation Panel And Detaching The Filter
Step 2: Unfastening the operation panel CAUTION and detaching the filter If further support is needed to prevent the Open the packaging and take out the indoor unit from falling down, a protective wedge unit. Remove the protective tape and any can be installed. -
Page 25: Applying The Sealant Putty And Installing The Wall Hole Cover
NOTE Arrange the piping so that the drainage hose is on the bottom, the connecting piping is in Only models with a ventilation function • the middle, and the electrical wiring is at the contain ventilation ducting. top. The amount and type of electrical wiring •... -
Page 26: Connect Drain Hose
Indoor Drainpipe Installation Wall Outdoor Indoor Glue Drain pipe Drain pipe Band for covering the pipe ≈ 0.5~1cm 1. Make sure the drain pipe is connected to the / 0.2~0.4 inch outdoor side downward. 2. The hard polyvinyl chloride(PVC)plastic pipe 3. -
Page 27: Outdoor Unit Installation
Outdoor Unit Installation Install the unit by following local codes and install unit in the following locations: DO NOT regulations , there may be differ slightly Near an obstacle that will block air inlets between different regions. and outlets Near a public street, crowded areas, or where noise from the unit will disturb others Near animals or plants that will be harmed by hot air discharge... -
Page 28: Install Drain Joint
Step 2: Install drain joint IN COLD CLIMATES (Heat pump unit only) In cold climates, make sure that the drain Before bolting the outdoor unit in place, you must hose is as vertical as possible to ensure install the drain joint at the bottom of the unit. Note that there are two different types of drain swift water drainage. - Page 29 Rows of series installation The relations between H, A and L are as follows L ≤ 1/2H 25 cm / 9.8” or more L ≤ H 1/2H < L ≤ H 30 cm / 11.8” or more Can not be installed L >...
-
Page 30: Refrigerant Piping Connection
Refrigerant Piping Connection Indoor unit/ When connecting refrigerant piping, Outdoor unit do not let substances or gases other than the specified refrigerant enter the unit. The presence of other gases or substances will lower the unit’s capacity, and can cause abnormally high pressure in the refrigeration cycle. -
Page 31: Remove Burrs
5. Clamp flare form on the end of the pipe. DO NOT DEFORM PIPE The end of the pipe must extend beyond WHILE CUTTING the flare form. Be extra careful not to damage, dent, or deform the pipe while cutting. This will Flare form drastically reduce the heating efficiency of the unit. - Page 32 2. Align the center of the two pipes that you NOTES ON MINIMUM BEND RADIUS will connect. Carefully bend the tubing in the middle according to the diagram below. DO NOT bend the tubing more than 90° or more than 3 times.
-
Page 33: Wiring
Wiring BEFORE PERFORMING ANY 9. Every wire must be firmly connected. ELECTRICAL WORK, READ THESE Loose wiring can cause the terminal to overheat, resulting in product malfunction REGULATIONS and possible fire. Do not let wires touch or rest against refrigerant tubing, the 1. -
Page 34: Outdoor Unit Wiring
NOTE ON AIR SWITCH Air switch When the maximum current of the air conditioner (purchased seperately) is more than 16A, an air switch or leakage Air switch (purchased protection switch with protective device shall be Indoor unit power wires seperately) used(purchased seperately) . -
Page 35: Indoor Unit Wiring
b. Using wire strippers, strip the rubber jacket 3. Connect the u-lugs to the terminals. from both ends of the signal cable to reveal Match the wire colors/labels with the labels approximately 15cm (5.9”) of wire. on the terminal block, Firmly screw the u-lug c. -
Page 36: Air Evacuation
Air Evacuation Wait for 5 minutes, then check that there Preparations and Precautions has been no change in system pressure. Air and foreign matter in the refrigerant circuit can If there is a change in system pressure, refer cause abnormal rises in pressure, which can damage to Gas Leak Check section for information the air conditioner, reduce its efficiency, and cause on how to check for leaks. -
Page 37: Note On Adding Refrigerant
Note on Adding Refrigerant Some systems require additional charging depending on pipe lengths. The standard pipe length varies according to local regulations. For example, in North America, the standard pipe length is 7.5m (25’). In other areas, the standard pipe length is 5m (16‘). The refrigerant should be charged from the service port on the outdoor unit’s low pressure valve. -
Page 38: Test Run
Test Run f. Check to see that the drainage system is Before Test Run unimpeded and draining smoothly. A test run must be performed after the entire g. Ensure there is no vibration or abnormal system has been completely installed. Confirm noise during operation. - Page 40 The design and specifications are subject to change without prior notice for product improvement. Consult with the sales agency or manufacturer for details. Any updates to the manual will be uploaded to the service website, please check for the latest version. CF001UI-J...
Need help?
Do you have a question about the FPA-400IGM and is the answer not in the manual?
Questions and answers