Table of Contents
Advertisement
3. Full spectrum - "Max zoom in" - Span Min /Span Max.
This function makes it easy to "jump" between full spectrum (920-2150 MHz) to
"Max zoom in" (250 MHz bandwidth).
The "Max zoom in"-function is very good to use when adjusting the cross-polarisation.
• Move the cursor to any desired frequency (peak).
Push the nr 3 button (span Min) on the keyboard.
The instrument will "zoom in" max. at that selected frequency (250 MHz bandwidth).
Rotate the LNB so that either the Horisontal or Vertical polarisation will be in its max-
position –adjusting the cross-polarisation.
Pressing the nr 3 button again (span Max), gets You back to "Max zoom out".
4. Atten
Attenuation 15dB. Manuell on/off with button nr 4.
Selected position is displayed at the right hand side of the monitor.
5. DiSEqC
instrument.
Submenu 7 (SWx) shows the extended DiSEqC 1.1 commands.
Submenu 8 (Motor) shows the DiSEqC actuator-control commands (DiSEqC 1.2).
Even 13/18V and 22 kHz on/off can be adjusted in this mode.
6. Setup
Basic-operation setup:
1. LNB L.O. Select the LNBs L.O. for showing the correct LNB frequency.
2. Digital. Select the satellite-type. Europe uses DVB (DBS).
DAWNco • 3340 S. Lapeer Rd • Orion, MI 48359-1320 • Ph (248) 391-9200 • Fax (248) 391-9207 • sales@DAWNco.com
Chose DiSEqC command by using the keyboard on the side of the
Default setting is button nr 9 (IF).
USA and Japan uses DSS.
(8)
Advertisement
Table of Contents
