Maintenance - Dawnco STARLOOK- D Manual

(13)
IV. Maintenance.
The instrument is equipped with a rechargeable battery and it is important that the battery is
maintained.
Recharging should be done with the, enclosed car-adaptor or external power supply of
220v/13.5v DC, centre-pin -plus and chassis -earth.
Note, the instrument can be operated, for shorter periods of time, by the external
power supply. However, the STARLOOK- D is not made for permanent operation.
Contact your dealer for more information.
Adjustments for vertical hold, brightness and contrast are located under the instrument.
Contact Your dealer for proper adjustments.
The battery needs recharging when the battery-symbol at the top of the LCD-display is empty.
Remember that a cold battery has much lower capacity than a warm one.
SAT LOOK Digital is designed for outside use in rough conditions but it should not be exposed
for rain or snow as this can damage or shorten the lifetime of the instrument.
Checking/charging the battery.
As the instrument has been stored for some time before transportation it is important to check
the battery-condition.
To do this turn the main switch On.
When starting the instrument, the monitor and LCD-display turns On.
There´s a battery symbol at the top of the LCD-display that shows the status of the battery. All
black means that the battery is fully charged. If the symbol is empty it means that the battery is
empty to.
If the battery needs recharging, use the power-supply attached with the instrument.
A thermometer-scale (0-100%) will lit on the LCD-display as the recharging starts.
Notice. The instrument should be turned of when being recharged.
Recharging from fully discharged battery to about 98% capacity takes aprox.30 hours.
When the battery been recharged, TV LOOK is ready to be used.
DAWNco • 3340 S. Lapeer Rd • Orion, MI 48359-1320 • Ph (248) 391-9200 • Fax (248) 391-9207 • sales@DAWNco.com