Information; Functions; Picture - Dawnco STARLOOK- D Manual

The control-button handle a few important functions (Should be controlled by this button). It
is important to learn how to use the control-button in order to handle the STARLOOK- D
easy and correct.
The functions of the control-button in the different modes.
Spectrum:
Frequency
Bandwidth(span)
When the STARLOOK- D is in Frequency-mode, the cursor is controlled by the knob.
Try to move the cursor up/down by turning the knob left/right.
D. Information:
The cursors position (frequency), the spectrums startfrequency (920 MHz), the spectrums
stopfrequency (2150 MHz) and bandwidth (1231 MHz) can be read out on the picture-
screen.
The most important measured data , the dB-value, is shown in the middle of the monitor.
Measuring of the tuned in frequency is done continuos and the presentation is being
updated a couple of times per second.
III. Functions
The instrument starts with the MAINMENU where the following functions can be choosed:

1. Picture

After choosen a certain frequency it´s easy to access the TV-mode by pressing button nr 1
"picture" in the Mainemnu.
- The knob controls the frequency-position in this mode but the function change when the
control-button is pushed (the function choosed is displayed on top of the LCD).
The function switch between Frequency and Memory.
Measuring on a certain frequency can be done in this "Picture"-mode (dB-value is shown
in the LCD-display).
DAWNco • 3340 S. Lapeer Rd • Orion, MI 48359-1320 • Ph (248) 391-9200 • Fax (248) 391-9207 • sales@DAWNco.com
Picture-mode:
Frequency
Memory
MAINMENU
TV-mode.
(4)
Digital-mode:
Frequency
Memory