1. Pedal 2. Buffer Switch 3. LED On/Off Switch 4. Mid Frequency Switch 5. Range 6. Wah LED 7. Pedal Tension Adjustment 8. Input Jack 9. DC Power Connector 10. Output Jack 11. Battery Compartment (not shown)
Page 3
WAH PEDAL ™ Thanks for purchasing the Tread-Light Wah Pedal—a stylish re-imagining of Fender’s FWP-1 wah pedal of the mid-2010s, which is prized for its full-bodied tone, smooth feel and rugged build. The Tread-Light Wah has the historic FWP-1 circuit, sound and switchable classic or bufferd output, but there’s also much more—including...
Page 4
Pedal Engage wah effect by rocking pedal back and forth; Wah LED (below) will illuminate when effect is active. Pedal rocker motion can be loosened or tightened using Pedal Tension Adjustment mechanism. Buffer Switch Toggles between classic output in OFF position and buffered output in ON position.
Battery Compartment Battery compartment cover on underside of pedal snaps open and shut easily; compartment houses single 9-volt battery that lifts out easily for replacement.
Page 6
Pedal Tension Adjustment Loosen Tighten To loosen or tighten rocker movement of pedal, pry cap from right side of pedal with a small flat-head screwdriver; use 10mm socket wrench to adjust nut to pedal motion preference. To avoid damage to pedal assembly, do not over-tighten.