Viconics GW2 Manual page 9

Room Controllers
This section shows you how to add VT7000/VT8000 Series Room Controllers as well as how to integrate them with the GW2.
Note
The below example applies to the VT7200 series room controller. Refer to the installation manual of your room controller model for the
exact key sequence used to navigate the various menus on the room controller.
Configure VT7000 Series Room Controllers
Press and hold OVERRIDE for approximately eight seconds until PaswrdSet shows.
1.
2. If password is required, using Up or Down arrow button, set Password to any value between 0 - 1000.
NOTE: only set password if necessary. Otherwise leave at 0.
3. Push OVERRIDE after Password is set.
4. Press OVERRIDE until PAN ID shows.
5. Using Up or Down arrow button, set PAN ID to match value set in GW2.
Push OVERRIDE after PAN ID is set.
6.
7. Push OVERRIDE until Channel shows.
Viconics Technologies
028-0465-00
9
October 2015