Specifications - Makita DUC252 Instruction Manual

ENGLISH
(Original instructions)
1 Red indicator
2 Button
3 Battery cartridge
4 Battery indicator
5 Indicator lamps
6 Check button
7 Lock-off button
8 Switch trigger
9 Front hand guard
10 Lock
11 Unlock
12 Adjusting screw
13 Sprocket
14 Adjusting pin

SPECIFICATIONS

Model
Standard guide bar
Standard saw chain
Sprocket
Overall length (without guide bar)
Net weight
Chain speed per minute
Chain oil tank volume
Rated voltage
WARNING: Use appropriate combination of the guide bar and saw chain. Otherwise personal injury may result.
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
*1: Weight, without the saw chain, guide bar, guide bar cover, oil and battery cartridge(s).
*2: The lightest and heaviest combination of weight, according to EPTA-Procedure 01/2014. The weight may differ
depending on the attachment(s), including the battery cartridge(s).
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING: Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
10
Explanation of general view
15 Hole
16 Guide bar
17 Sprocket cover
18 Lever
19 Adjusting dial
20 Loosen
21 Tighten
22 Saw chain
23 Oil tank cap
24 Oil inspection window
(for refilling the tank with oil)
25 Oil inspection window
26 Spike bumper
27 Guide bar cover
Guide bar length
Cutting length
Sprocket nose
Type
Type
Pitch 9.5 mm (3/8")
Gauge 1.3 mm (0.05")
No. of drive links
Number of teeth
Pitch 9.5 mm (3/8")
*1
*2
BL1815N / BL1820B / BL1830B / BL1840B / BL1850B / BL1860B
DUC252
250 mm
23 cm 24 cm
Carving bar
bar
91PX 25AP
6.35 mm (1/4")
1.3 mm (0.05")
40 60
6 9
6.35 mm (1/4")
8.3 m/s (500 m/min)
D.C. 36 V
DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF /
28 Battery cover
29 Cutting length
30 Distance between cutting edge
and depth gauge
31 Minimum 3 mm
32 Side plate angle
33 Slotted screwdriver
34 Locking ring
35 Limit mark
36 Brush holder cap
37 Screwdriver
DUC302
300 mm
28 cm
Sprocket nose bar
90PX
9.5 mm (3/8")
1.1 mm (0.043")
46
6
9.5 mm (3/8")
316 mm
2.9 kg
4.1 - 4.7 kg
3
85 cm
D.C. 36 V
DC18SH