L3 Stormscope II Series User Manual page 20

Error Messages
ERROR
Error 19
Processor Fault
Error 20 Configu-
ration Changed
Error 21
Processor Fault
Error 22
Invalid Synchro
Signals
Error 23
Invalid Synchro
Ref
Error 24
Mic Key Stuck
Errors 35 and 36
Processor Fault
Errors 35 and 36
Processor Fault
Error 40
Processor Fault
*F=Fatal, NF=Nonfatal, R=Recoverable, NR=Nonrecoverable (Description
follows table.)
3-4
Table 3-1: Error Messages (continued)
FAULT SOURCE
Main Processor
data overload
Antenna jumper
configuration
changed since
last time power
was applied to the
system
Main processor
Invalid XYZ input
(gyro may still be
spinning up)
No 400 Hz refer-
ence
Mic key (inhibit
line) stuck. The
microphone key
has been de-
pressed for more
than 1 minute
DSP or main
processor
DSP or main
processor
Main processor
Chapter 3 - Operation
TYPE* RECOMMENDED ACTION
NF/R Continue without weath-
er mapping functions.
See your dealer for
service if this error oc-
curs frequently.
NF/R Select antenna location
via MFD. If selection
matches processor con-
figuration jumpers, nor-
mal operation returns. If
not correctable, continue
without weather mapping
functions and see your
dealer for service.
F Turn off the unit and see
your dealer for service.
NF/R Continue without head-
ing stabilization. See
your dealer for service.
NF/R Continue without head-
ing stabilization. See
your dealer for service.
NF/R Turn off the unit and see
your dealer for service.
F Continue without weath-
er mapping functions.
See your dealer for
service.
NF/R See your dealer for ser-
vice if this error occurs
frequently.
NF/R See your dealer for ser-
vice if this error occurs
frequently.
Stormscope WX-500 User's Guide
®