Advertisement
Using the emergency hand crank
Warning:
Do not use the crank to assist an operating winch. This will damage the winch
and may cause personal injury.
1. Turn the clutch knob clockwise until hand tight. Do not force or overtighten it.
2. Place the end of the hand crank over the flattened end of the threaded shaft on the left side of
the winch.
3. Rotate the hand crank clockwise to tighten the cable. Continue to turn until the cable has been
completely retracted.
Maintenance
1. Occasionally lubricate the cable with light oil.
2. Grease the gears every 6 months. To do this, remove the clutch knob and separate the left and
right housing. Use any good-quality waterproof grease.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 61000–61002, 61769
Page 8
10
2021-1
Advertisement
